How to Install a Bathroom Faucet | A DIY Guide

In this video I'll walk you through all the steps of installing a bathroom faucet including the drain and trap assembly.
=======================================
=======================================
►How to Tile a Bathroom Floor:

[daniellegershen]

I really needed to see a more detailed step by step. but if I just needed a quick how to, this was good.

[jaclynb_]

Good info, just extremely fast paced for this newbie.

[tommyrox]

After a new faucet install (Kohler Cursiva) the base on the cold handle turned with the handle. I called support with no help but to send me a new faucet. I have loosened and tightened this for a solid week. Looking to see on YouTube for any known issues...you fixed my problem in about 5 seconds. The directions do not tell you to tighten the base from the top...all fixed! THANK YOU!!!! And wife thanks you...she has heard me cussing this whole time. 🙌❤❤❤🍻

[MrTalmaguer]

Very well explained. Great video and thank you. It helped me a lot before tackling both sinks

[athreeboy]

You should have showed how to take the old one off.

[vanessabeene]

Hey would you mind posting all the parts you used?

[davidharrell]

Love the rating system! I recommend you remove the faucet screen filter before turning the water on for the first time. This will avoid it clogging.

[BruceAUlrich]

Great info! Love how clearly you explained everything!

[annieedwards]

I like the content. Very easy to follow instructions.

[Chogogo]

Your f-bomb project rating is awesome 👹

[WForrestFrantz]

Loved it. Thanks.

But I always put the locking clamp so that it contains the lift strap when installing it to the ball rod (so it can't slid off the ball rod or get jammed by moving further onto the ball rod). To do this, put one side of the clamp onto the ball rod, then the lift strap, then the other end of the clamp and move it to the right location. In this way, the lift strap stays secured.
Also, it is easier to put the tape onto the ball thread before installing the drain.

Thanks again. I always read directions, watch your video to help me understand the directions, then install reading the directions again.

[robertp]

Thank you very much for the great explanations.
Perhaps, in the future, you might make a "trouble-shooting video" (old, rusted parts, bad seals, other common obstacles to a clean install).
.. I'm a the point where the old faucet's retaining nuts are so difficult to reach, that I'm considering removing the sink, installing new faucet, then re-installing the sink.
Sounds like fun, right? (I'm actually dreading it).
Thanks again for the nice video.

[duvo]

Great! I have learned this awesome job! Thank you so much

[prahalaparthasarathy]

Would be nice if you include removing old faucet

[nancypearson]

Thanks for the video, if was helpful.

[marleshakeys]

I like the f-bomb scale. 😂 That is helpful.

[denniswilganowski]

Wish you would have shown how u tightened the nut on the underside. Did u use a basin wrench?

[Shahzad]

Great video, your commentary was a little too fast for me, and I am one of those 'reluctant' ones that you mentioned, especially when it comes to replacing plumbing hardware. Finally, thanks for educating non-tech people like us.

[garyshaw]

Can you recommend a widespread *" faucet that has a spout like 7 or 8"? I want the faucet to pour or aim closer to the middle of the sink vs the back wall of the sink. Thank you.

[MichelleWashington-vt]

I have the same facet but one handle turn to much. The handle is too loose.