Quick Tip: Set Your Kreg Rip-Cut™ for Accurate Cuts

Setting up your Kreg Rip-Cut™ to make fast, accurate cuts is a quick and easy process!

[Ron-rbvw]

Seriously. Great video. I watched of bunch of other videos and the over complicate it or get it wrong. Way easier how you did it. This video link should be included in the box for people.

[JarredSutherland]

I wish I had watched this video a couple years ago, this made adjusting things super simple. Thank you!

[daviddaigrepont]

Thanks! I was about to throw this thing away! None of the other videos showed how to align the blade

[kenmcf]

You technique for setting the guide line is big brain. I have watched a few other vids and they just do a test cut...I have the rip cut jig just have not opened it yet..soon.

[PeppersPlantsnPowerTools]

THANK YOU!! The visual is SO appreciated!

[BTNomad]

Perfect. Using mine today for the first time.

[mac]

Great visual tips makes setting up understandable thanks

[paulfeiger]

Thanks. Have the jig, but couldn't figure out how to really line up the cursor and blade. Able to now.

[richardayala]

Wow! How easy and clever, thank you!

[jay.c]

ok now I got it. I was using this thing to draw straight lines cause I couldn’t get sht lined up 😂 I gave up weeks ago and finally decided to look it up

[wmbhjnd]

geez, this seems so obvious and simple but i was questioning how to get set that adjuster thingy lol

[tonyhemingway]

I own one and have discovered that the set screws, that hold the saw in place, aren't very dependable.

[Freeman]

where is the video on how to setup the rip-cut??? Owner's manual to complicated to understand, visual is much easier to grasp and faster. PLEASE post the setup instructions!!!!

[mathewshoyt]

didn't read the directions. came straight to youtube for setup.. my saw is calibrated dead on!!

[nickfonseca]

I cant get the guide to zero out on my "Skil" saw. The foot fits but the little clear bit is in the "look in the manual" section. I guess that means it doesn't fit my saw. I ended up unplugging the saw and measured my distance from the blade to the guide. It technically isn't the right way to do it but it worked. Good thing my tolerances are such that a 16th or 32nd isn't the end of the world. It would have been nice if it fit my saw though. It is an older saw, but there is no reason to trade it in for new one just to fit the accessory; the saw works great.

[jeffhebert]

thanks now I know how to get it setup now. also i'm guessing that if you take the saw off then you have to do this every time. or is it recommended to leave the saw attached.

[tassie]

I recently purchased the Kreg Rip-Cut and I am so pleased with the product that I would like to expand my collection and get the Accu-Cut also. My question is, knowing that the saw sledge fits both products, can I buy just the Accu-Cut rail without another sledge that I don't need?

[llewellinfelon]

Frustrating. When I push the guide arm/rail so it is touching the blade, the cursor comes out of its slot when aligning the red line with the zero mark in the guide arm. Does this not work with an M18 7 1/4 saw?

[davidfurlano]

All of my cuts start really tight. Terrible wobble at the start of the cut for the first 12”. Eventually things start moving smoothly but have yet to make a straight 22” cut for 8 feet.

[hugomunoz]

Is that easy I already spend few hours to make it right