Did You Know - 4-Pin 26W CFL to 4-Pin 13W LED Lamp

Here we show you how to swap / retrofit a 4-pin CFL to a 4-pin LED lamp (bulb). It's plug-and-play! No rewiring is necessary and it's as easy as changing any light bulb. You cut the wattage in half and extend the life of the bulb by up to 5 times or more.

The CFL contains mercury and lead. They typically don't last as long as desired or advertised. The more they are cycled (turned on/off), the faster they degrade and fail. LEDs do not suffer from this and provide instant, full brightness from the moment they are turned on!

Products demonstrated are a 26w CFL being replaced with a 13w LED. 4-pin LEDs are available in a vertical or horizontal configuration.

Visit us at:

[fulj]

What about the ballast unit? I thought it needed to be bypassed for an LED light to work?

[chrisscull]

What ballast can i use now that its a lower power draw

[KevinNguyenTu]

When you replace the CFL to LED, don't you have to remove the ballast? 

[karenmassey]

What about a deep can? We have the new LED, but since it is far back in the fixture, we get some undesired shadowing on the walls.

[marcisrancans]

LEDs in terms of energy effieciency are great, BUT when it comes to output light frequency spectrum, how compareable are they?

[michaelsantiago]

Hi! Do you have an authorized distributor here in the Philippines? Thanks.

[spencergodspeed]

My 4 Pin LED's flicker, any solution for this?

[LaniSalter]

Hi Travis. I am trying to REPLACE the 13 PL-C 4-pin with a the same but NEW bulb. However, I can not seem to get the G24Q-1 to push into the socket. WhatAm I doing wrong?

[audionet]

If I switched my current 13W 4-pin CFL to these LEDs can I dim them? My current lights cannot be dimmed and it drives me crazy.  Thanks

[mousy]

my can used to have a fluorescent pl-t and i installed a new led pl-t. after a few min the led would turn off. any idea why?

[stockjonebills]

You say no delayed start but there was a delay when you turned on the light?