Caulk Gun repair (DIY)

[melman]

my plunger thingy unhooked from the back... can't get it clipped in again😥

[jamescoulton]

Im at home depot and you just saved me $10

[badwolf]

Mine was all rusted up, but seeing yours I could see what the issue was. Bit of oil and a scrape and the little bastard worked again.

[MarcoPerez-lhru]

Thank U. I bought one in Sherwin Williams and is not working properly, am going to check if is bent tomorrow.

[mauliksital]

the minimum required thickness of sheet used to make trigger should be 1.2 mm, chinese manufacture use 0.6mm thats why it bends like this

[wpegram]

Likely a good video, but the music is too annoying.

[sugarfitz]

thanks. I learned how it worked thanks to you. oh but idk what happened to the silicone... more came out the sides then the tip. :/

[Debidawg]

Any advice for a rod that won’t retract?

[hilariohernandezandaverde]

están hechas para uso corto por fallas de fabrica o conveniencia del fabricante. si quieres que dure mas tienes que doblar la platina que sirve para quitar la presión. el uso de esa calafateadora va doblando esa laminita o plaquita hacia a dentro ocasionando que se salga y si la varilla es hexagonal tienes que desarmarla y volverla a instalar, ok pero cuando la pongas el doblez que se hizo por el uso, ahora ponla hacia afuera o hacia la mano, esto sucede cuando el silicon esta duro o ya no sirbe y forzamos la salida del silicon sería bueno calentar o ablandar con calor el silicon antes si vez que esta dura o usar uno nuevo.

[edithyolandalobonotani]

Pude arreglar el mio, muchas thank you

[dannyhowell]

If you are going to post something at least show the fix otherwise don't make a video about something I already know