Quick Base sanding Tip

Car Painting base coat Denibbing

[Mechaniclyfe]

Good tip, I do this a lot since I paint in a garage and I get a lot of “stuff “ floating around.

[luckylegs]

this helped me so much i had a couple runs and sags in a side skirt and the 600 took it right out.
Then i laid base right on top of that and it didn’t show through!

[ARIASPHIL]

What’s up brother. Thank you for delivering all this great tips

[chanceschneider]

It also helps A LOT to use am air blade like a walcom while you're sanding, it keeps the base from balling up and sticking on the panel. Especially since ppg takes forever to completly dehydrate to there it will just dust up. Idk why the blacks are so bad I never tack them after sealer.

[madisonmarlow]

Great tip! Hope the color turns out good. Have a nice one Gabe.✌️

[kimojoseph]

Great 👍 tip Gabe glad to see you brother thanks 🙏 for the information ℹ️ usefully to me keep it up and keep making more videos Gabe

[timgiesin]

Hope this works I thought I was done sanding until I started spraying then surprise I wasn't done sanding lol

[ocsplc]

Ok, I’m DIY’ing my VW atlas with some minor bodywork, but the hard part is the paint. I’ve read and watched as much as I can. Many seemingly qualified people say don’t sand your base coat. Also, what is “de-nibbing?”

[lukeburritos]

What helmet and respiratory system do you use . The ones at my work are trash. And yours look nice

[BigGeorge]

You deliver great tips! However I sure wish you could paint my car!!!

[Z-Ack]

I went through filling and sanding primer where its even and flat but the damn base coat i have to wet color sand it to get the metallic and flake to match right but i dunno how to stop from rubbing through the base in some spots where theres primer .. i know the primers right because i used a powder to test high/ low spots.. but i dunno what to do aside from completely sanding and redoing the entire thing. Doing a deep scratch dent repair on a fender. So if i add more base coat to the area then it will stand proud of the existing but if i dont then i rub through.. is there such a thing as denting the area more then fill to where i can put on more layers of base to match it or will that cause issues with the extra filler and base? Or do i overlap the base on the existing base then trry to feather that over a larger area?? Im about ready to take a chainsaw to this damn thing and call insurance.. lol

[lockstocky]

Can this be done with water based as well as solvent ?

[ilusomu]

what do to if the painter already clear coat but it have orange peel on the basecoat?

[bodytm]

600..? And everything is looking nice after one or two coats of base? I use 800 sía velvet then correct it 2000 sia velvet I would be afraid to use a stronger one 😅

[tajungkang]

Im painting solid dark grey, is it ok if i sanded the base 1500 and clearcoat it without spraying another layer of basecoat?will the 1500 scratch show after clear?

[RC.]

Just finished three coats of base, but I did not have my tape for soft edge, I have hard edge lines in the middle of my door panel, how do I get rid of the herd edge before clearcoat?

[IndoMaN]

Sir how to remove easily old paint completely from car without much sanding..is there a video complete car paint job..from removing old paint to painting new paint..

[boddyxpolitic]

Gabe do you put hardener in the base ?

[chrisoo]

Watching this video while my sealer is drying

[DesiJattUk]

You going a great job mate can you give any tips so how can I improve my painting can you watch my channel to let me know please 👍