Cut and Etch Weld Testing - Juba ZX7 - 200 Inverter Stick Welder

Cut and Etch Weld Testing - Juba ZX7 - 200 Inverter Stick Welder - Let's do a cut & etch test on a cheap Chinese inverter stick welder to see how it performs.

DON'T FORGET TO LIKE COMMENT AND SUBSCRIBE

Cut and Etch Weld Testing Harbor Freight Flux Core Welder Mods

Top videos you need to see:

If you would like to help support my channel and use the WannaBFree Amazon affiliate link, I thank you in advance for your support. As an Amazon Associate I earn from qualifying purchases and no extra cost to you.

ZX7-200 220V Portable MMA ARC Welder DC IGBT

ZX7-200 220V Portable MMA ARC Welder DC IGBT (Digital Version)

PRIMEWELD TIG225X 225 Amp IGBT AC DC Tig/Stick Welder

EATON S42-SP wall plates, Black

Eaton 1254 50-Amp 2-Pole 3-Wire 250-Volt Heavy Duty Grade Flush Mount Power Receptacle, Brown

Sigma Electric 14250 1/2-Inch 3 Hole 1-Gang Box, Gray

Sigma Electric ProConnex 18051 NM/SE Clamp Type Connector 3/8-Inch, 4-Pack

Black Duck Brand Male Extension Cord Replacement Electrical Plugs End (5 Pieces)

SÜA 500 AMP Stick Welding Electrode Holder AF50 Style

400 Amp Brass Welding Ground Clamp

WeldingCity E71T-GS Flux-Core Gasless Mild Steel MIG Welding Wire 0.030" 10-lb Spool

WannaBFree Amazon affiliate link

[standonit]

You get another thumbs up from me Bruce!!
Good stuff you're doing!

[bigtb]

Sorry I haven't gotten around to testing the draw of this welder. I've been really busy with work and a little renovation around the house. One of your replies made it seem like you were actually looking for the output numbers. I did test that before my review and found the max output was around 120-125 amps when maxed out (display says 200). But I haven't had a chance to test the draw from the wall yet. I hope to do that testing soon.

[markbreidenbaugh]

Electrode positive gives deeper penetration, electrode negative is shallower penetration.

[AbbyKepa-gige]

I have one welding machine with me but the problem is when I switch it on the power comes on but when trying welding it doesn't weld. Can someone help out how to fix fix this

[andrewsturgess]

I am awful with all the electron flow but if the current is running from the electrode to the work piece then that is best penetration/most aggressive arc.
I'd suggest even doing a cut and etch with tig, you would be surprised on how many voids you can find in a multi tig weld or how deep or shallow your pen is on the same setting with different grind angles.

[queenarc]

1/3 of the arc energy is in the - pole and 2/3 in the +pole.Take a look at the some wave on google. So you get more penetration with electrode +.

[williamgalloway]

for these little inverter machines just buy 2 or 4 guage jumper cables on ebay. 20 - 25 bucks for a set of 20 ft. leads

[PierreMailhot-gqrl]

Dry by steaming your baguettes in the oven at 300F for 20 minutes, or if it's winter on top of your wood stove. 20 minutes, a baguette cannot be steamed more than 3 times, then trash.