Add Loads to the Beam in SAP2000

preview_player
Показать описание

  1. Sami El
  2. hamid
  3. el
  4. darwich
  5. concrete
  6. reinforced
Рекомендации по теме
Add Loads to 0:06:36

Add Loads to the Beam in SAP2000

CSI ETABS - 0:06:50

CSI ETABS - 03 - Assign Loads on Beam (Point Load, UDL , VDL) (Part b) | Part 8

How to apply 0:05:09

How to apply Two Point Load On a beam in Staadpro?

I Installed a 0:00:43

I Installed a Load-Bearing Beam with No Experience

Tekla Structural Designer: 0:03:42

Tekla Structural Designer: Applying Point Load to a Beam||UDL on Beams

HOW TO APPLY 0:10:03

HOW TO APPLY BEAM WALL LOAD ON PROTA STRUCTURE

Sketch the loading 0:02:31

Sketch the loading that acts along beam members BE and FED

Analysis of Beam 0:06:05

Analysis of Beam with Point Load using STAAD.Pro || Steps Explained

ETABS Building Design 0:22:46

ETABS Building Design Tutorial, etabs software for civil engineering beginners #etabs #etabstutorial

how to remove 0:01:54

how to remove internal load bearing wall with steel beam RSJ installation | London

How to Model 0:09:22

How to Model A Simple Beam in Autodesk Robot

How to Calculate 0:04:37

How to Calculate Support Reactions of a Simply Supported Beam with a Point Load

How to Apply 0:11:24

How to Apply Point load In Simply Supported beam with Full Concrete Design in Staad Pro?

🇺🇸 Video 2 0:07:08

🇺🇸 Video 2 (Sizer US) - Beam Load Input

BEAM TUTORIAL #1- 0:17:03

BEAM TUTORIAL #1- Analysis of Beam in SAP2000

Simply supported beam: 0:12:22

Simply supported beam: Modeling, analysis and design in STAAD Pro

How to apply 0:06:56

How to apply moving load on beam using Staad Pro

How to Attach 0:02:06

How to Attach a Beam to a Post for a Deck | Decks, Docks & Gazebos

How to do 0:11:32

How to do a steel beam calculation

Loading a beam 0:06:32

Loading a beam with Member/Manual load in ProtaStructure.

How to Identify 0:04:59

How to Identify and Remove a Load Bearing Wall | Ask This Old House

Trapezoidal distributed load 0:10:50

Trapezoidal distributed load on Beam

9 Beam Loads, 0:11:32

9 Beam Loads, Partition Wall, Load Editor

I Broke These 0:09:12

I Broke These Concrete Beams - Design Principles from Beam Failures

Комментарии
Автор

Thanks for the video. I'm not an estructurist, but I have a doubt. If the case there're more than one load, what is the minimum distance between them. Because, AFAIK, when you divide a beam, then SAP2000 it delivers two new beams. For example, If you divides the beam by 3 loads equitative at relative distance of 0.25, 0.5 and 0.75, then you will have the beam splitted by 4 new beams. Is SAP2000 puts any restriccions about how much/many divisions you apply in a single beam ?

jespa