EBYTE E32 LoRa Transciever - Advanced Arduino Setup

This video demonstrates how to connect the EBYTE E32 Transceiver to the Arduino Uno and Nano. I showed in a previous video a simple setup, whereas here I am presenting an advanced setup with a quick glance on some configurable parameters.

The Ebyte library is written by Kris Kasprzak. You can find it in the link below:

[Ldoc]

communication level should 3, 3V. In spec it s written For 5V TTL, it may be at risk ofburning down""

[bobbyarmasugaras.t]

hi, how can i declared this in arduino ide ? >>OPT_TP30' was not declared in this scope

[berkayuysak]

how can i configure this module? i want point to point communication
i use e32-ttl-1W

[s.husain]

How to set up lora wake-up sends the data and goes into low power mode sir how to do this configuration in arduino

[fadlipadriyana]

hi, thanks alot
but i need to know how you can guess the air data rate is according to set spreading factor too, in manual book i didnt get this information

[nickleather]

Hello, I try to use E32 with Arduino and STM32 but I have a problem about configuration. I can open RF Setting and openPort but when i push getParam i get an error: "No response this module." How can I configure my modules? I tried many things but I could not solve this problem. It is so important for me. Please help.

[anas.ghouila]

Hi, i have a question..
Does the Ebyte Sx1276 lora module work (send and receive data) without antenna?

[Maxbl]

Hi, where did you get the table for SetAirDataRate? I can't find this info anywhere else. I'm trying to make ebyte communicate with ttgo lora 32 with no success. Ebyte can talk to other ebyte and ttgo can talk to other ttgo, but not ebyte <-> ttgo

[bassemgatowani]

Thanks 🌹
Can we used to be telemetry for drone

[DavidLApiculteur]

hi, i need to send data with E32 on ttn (thethingsnetwork) how can i find an arduino sketch because i need. reagrds

[nitishsharma]

Sir, what if connection's are same but unable to begin device

[luisgerardohernandezduque]

Hello, very good example, I need to ask you something, can I use (TRANSCEIVER.SENDSTRUCT and TRANSCEIVER.GETSTRUCT) in the same module, to receive and send data at the same time, more like a bi-directional communication.

[bobbyarmasugaras.t]

Hi, Can you show the result from this video ? bcz in my prjoect the arduino ide coding can't running. Please Sir.

[erimenwa]

Hi, can u tell me where u get data reference about SetAirDataRate

[ragulharisankar]

How to make simple message transmission using Ebyte & Arduino. Please make a tutorial on it.

[shammashuq]

Hi, Can I use the device to send data from an arduino nano to my laptop with an rtl - sdr?

[ashkananali]

Hi. Thank my friend how connect talmatry RFD 900 MGHz weth Ardunio control servo

[Bardum]

Hey dude nice video helped me a lot, can you help with printing the info into an oled with arduino on the rx??

[durgavaraprasaddummugudupu]

I want aurdino code for ebyte e22 lora module

[s.husain]

How to set low power mode in arduino sir