26. Set key and frequency to Ebyte LoRa. Secure Transmission.

Ebyte UART LoRa RF Settings. Change address, channel and key

[jeffschroeder]

Your video was very helpful. I am making a LORA mailbox notifier to save me unnecessary trips down my half mile driveway. Thank you!

[saharkhdhaier]

can i disable the encryption system of Ebyte LoRa module in order to communicate with other devices?

[SirAuronn]

Once configured using this software, do I need to declare the LoRa address and key in the code for communication to occur between the LoRa transmitter and receiver? How would it be?

Excellent video!

[ycemilk]

Thank you for your excellent content! It was very helpful. May I ask a question? How to change these values on Arch Linux? And I want to ask about how to send the data from sensors with STM32 and LoRa E32 433T30D?

[alidemir]

Are there any way to do this without converter. Can I do this thing from stm32 ?

[mrafayshams]

How can we do this in real time through the microcontroller? Meaning hoe can we send a uart command through the microcontroller to set the address and key?

[richonguzman]

Is there a way to configure through Python???

Or after the configuration In the pc, is it fixed and could be called by Python through serial?

[bernardoguerra]

Hi, im trying to use it but i get the message ' no module response'. I have the E220-900T30D and i have the E220_v1.0 user interface.
GND to GND
VCC to 3V3
TXD to RX2
RXD to TX2
M1 to D22
M0 to D23
thats how i connected the lora module to the Esp32. i also tried disconnecting M0, M1. using also TR0 and RX0 but anything works.
i hope you can help me.
thankyou and best regards

[juanda]

please help sir how to get the rssi value of lora ebyte e22

[krishank]

He'll sir, I have a question.
I powered Tx with 3 AA type Cell. To save power, I want to use Sleep mode. For your confirmation, I am correct?

In loop starting

I will set M0, M1 : Low (to come in normal mode)

and After sending data,

I will set M0, M1: High (To sleep)

Then delay 10000


Is this ok? If I set Low and High in every loop, then its safe for module?
Is this work?

[nickleather]

Hello, I try to use E32 with Arduino and STM32 but I have a problem about configuration. I can open RF Setting and openPort but when i push getParam i get an error: "No response this module." How can I configure my modules? I tried many things but I could not solve this problem. It is so important for me. Please help.

[geotek]

hi, i have ebyte e22 400T30d 1w transciever and i need 5w ebyte transceiver, what 5w ebyte model can you recommend

[komaroviecoclubpodcast]

can I use ST-link V2 in order to program Lora modules or I need anything else? if yes pls tell me module I have to use. Thanx

[ahmedmoustafa]

The key is really short which make not secure !

[geotek]

Do you have official store or website?