Arduino DIYMore Mega Strong Fault Issue or Fake? & Servo Update

This fault has been raised via email to DIYMore awaiting a response from them. Update to follow once I hear from them.

The issue shows up when trying to use the device under i2c use it locks up while trying to scan. Also when I was using it for the 48 I/O nodes pin 21 when set as an output was being held HIGH forcing it to LOW only dimmed the LED attached not causing it to go out.

My apologises goes out if you have purchased one of these after seeing me using them in my videos.

I will continue to investigate this board to see if we can find other issues with it.