PlayStation 5 HDMI port replacement

Показать описание

Рекомендации по теме

Комментарии

Hello, I want to say Thank you to you. My old laptop stopped working yesterday. After checking the psu was working and the charging light was on, I did the measurement from a usb port which suggested no motherboard fault. I opened the case, I saw the pcb battery and took it out, put it back in after 10 mins. Bingo, all fired back to life. I feel you gave me the confidence to attempt this. Thank you.

donnybigboy

Thank you very much for this video, Sorin. With your help, another PS5 lives again. Your method worked really well, only thing I changed was I pre tinned the pins of the port first and made sure I had nice fluffy pillows of fresh solder and flux on the pads which seemed to help with less pins to touch up at the end. Hell of a ground plain on these eh !

Mark_C

You are Amazing man sir I have had passion for electronics and electrical maintainance and installation all of you sharing knowledge on you tube for free are amazing I have learnt a lot from you sir God bless you and your entire family

viktorchu

It's possible that the PS5 was set to 4K or some other display setting that your capture card or the display at your desk doesn't support.
If you turn it on by holding the power button down for 6 seconds it should boot into safe mode, which should display on any device.
Just for future reference!

fadetonoir

The most realistic video for replacing hdmi port for PS5 👍🏼 i like it thanks for sharing. I think i overheat my PS5 board during my try to replace the same

abdualrahmanmurshed

When the professor has to watch a tutorial 🤣🤦

latinofun

I know with the PS3 & the PS4, HDCP settings in the software won't allow you to capture from the Elgato so I assume that was the case here.

androxilogin

You're such a nice guy sir thanks for sharing all of your ideas hat's off to you sir💯

adriantech

BOM clerk to PS5 engineer: "How many screws to do you need?". "Yes".

DumahBrazorf

Not sure what I'm doing wrong but I've done exactly like you've done here 500 degrees 100% airflow on my rework station to try and remove a HDMI port from a laptop motherboard - after 5 minutes I give up as it's just not budging! Melted, but not budging :(

retrocomputinggrotto

Do you know where I can get hdmi replacement plug already tined?

theodoreharris

Hi Sorin, I need a bit of help. I have a Asus TP301UA, came in to change the screen, when I open it to unplug the battery before dismounting the screen, I noticed that near the lvds connector its burned, typical for when the cable is unplugged while connected. It looks like a capacitor, but what its burned its looks like an inductor or a coil. I cant locate the schematic, all I could find its a photo of the board where I could see how the components supposed to look like. I could send you a picture, but I guess its typical for the 19V lvds.

salvamipc