BUILDING A TUG BOAT SANDBOX JETSKI!! PART 8! PAINT AND THE ENGINE IS IN! THE TUGADOO VS THE TUGSKI!

#TUGSKI #RACING #TUGADOO #REBUILD #REVIEW

The tugadoo is finally getting painted and the engine is going in!!

Stay tuned for more vids!
If you like this vid please like, share and subscribe!
It means a lot and helps the channel grow!

Also check me out on Facebook, Instagram and tiktok!

[Jeep-Creep]

I don't know if anyone said it yet, but the Tugadoo looks better than Rusty Van Ranch's TugSki.... I am not sure why Rusty is ultra Tik Tok famous, I run a channel as well and I cannot seem to even get a lousy 1k subscribers, working on it, I know it will come, but some are famous it seems overnight. I think you have used better fabrication methods on your Tugadoo vs Tugski. The Tugski however I do like the windshield wiper and his steering control better. The Tugadoo has much better balance with the cab location, and I LOVE the extended cab, it is soo much slicker! The rear end flaring looks MUCH better than TugSki as well. I also LOVE the hook you made with the winch, you get TONS of points in my book on overall build, much better paint job as well! So yes, on my channel I also have a Tuggy for one of my 137 projects I am trying to do at the same time, you can check my builds, you have mad skills and I hope you keep cranking out these gimmicky projects! I love them! I know it doesn't pay the bills but man are they fun to watch. Are you going to do a GoKart challenge with Rusty? Or race him this summer? Maybe I will throw my hat in the ring, but I highly doubt I will have a as nice setup with similar power to both you and Rusty's Tuggy projects.

[scottham]

I hope you get a smart car that looks like a little tikes car to tow it!

[salvykc]

You need to allign your jugs or you will toast that crank and pistons, before you bolt down the cylinders you need to put on you exhaust manifold then torque down the cylinders, if you want it to last i would do it, good luck and I cant wait to see it finished!

[salvykc]

And get rid of those grey fuel lines or you will also toast your engine, basically they clog up and will gum up your carbs and it can blow your top end or just not run right at all, since it still had the grey lines I would rebuild the carb, or atleast clean it, and only get genuine mikuni carb kits, you can get them on amazon

[FoursquareT]

When do we get to see this thing in the water?

[ronaldpollak]

Just noticed, you need to clean the leaves and junk out of the inside. 😂 Also, you might want to order a wet suit. It’s going to be chilly willy once this is ready for water.

[angrymike]

The inside needs to be sand color not black ! Come on man !👍👌

[jonahsroka]

did you steal this idea from rusty ranch?