Composite Decking Install

#build #howto #deck #install #compositedecking #construction #contractor #stepbystep #hausplans
@hausplans

[alexayache]

I forget who but I seen some guys use a router on a stick. It worked like a charm.

[erikfrankfurt]

Wish I had a steady hand like you.
If I don't utilize that straight edge bar, then my cuts come out pretty frickin wonky.
Ask my old man about his stairs.

[garrettlanders]

Phenomenal craftsmanship. No tape on the top of those joists is going to create water trapped between the composite and tops of the joists though and rot them out even though they’re pressure treated. Just replaced 3 on my uncle’s deck because of that.

[theptownpunk]

Its that attention to detail's that show though... Good job.

[scottburnett]

Put a splitter in the middle so your not making seams on your deck boards

[bbdaman]

In the words of old greg. Yes sir thank you sir.

[wyattc]

Decking should never be staggered between only two joists, the decking is what gives the deck shear, so without it lapping at least three different joists (ideally more) it will pivot on those two joists and twist out of square. If it twists too much it can even cause the deck to collapse.

[noaiaemauri]

Yes!!!! a dewalt in this milwaukee video.. good!

[krzysztofszewczyk]

Piękna robota ale z takim sprzętem to się niema co dziwić 👏👏👏🏅🏅🏅

[cbdoil]

Tyvek puts the whole project in question.

[gesse]

Top, esse tipo de trabalho, parabéns, forte abraço...

[donaldjohnson]

Unless the homeowner pacifically requested it and you did not lay that plastic correctly you don't put the joint in the same spot every other joint you must stagger it number one it looks better number two it's more stronger but like I said unless the homeowner specifically requested it then that's what a rookie job looks like guys

[banjothehammer]

I almost shit when I saw that you didn’t have a Milwaukee tape to go with the rest of your Milwaukee tools

[WhateverItsanOpinion]

the problem with composite decking.. They only look good for about 4 years then they start to get faded is faded and washed out.. In 10 years they look terrible. I'd rather have Redwood Put water seal on it every other year the other year it always looks better than composite

[cjm]

I’m just wondering where the tape is going over the floor joist before the composite decking goes on. Without the tape on their overtime it will rot.

[DS-yukr]

Composite deck material gets as hot as asphalt if it’s in the sun. It will burn bare feet.

[barrymarson]

Trex or any composition decking material makes any deck looks better.

[dbzimhh]

Hate to be that guy but first thing I Stagger your joints looks better then the H pattern with all them seams in a line

[barwithm]

Would face screws not prevent the board from expansion and shrinkage of the boards?

[michaelscott]

I feel like if you were going to picture frame the deck, you should have put a two boards in so you didn’t have all those field seams.