Gearbox Mount Replacement - Peugeot 307

How to Replace the left-hand engine/gearbox mount on a Peugeot 307 from years 2001 to 2008. The torque setting for the center nut is 65Nm (48 foot pounds) and for the two bracket nuts the torque setting is 30Nm (22 foot pounds). Thanks for watching. Please comment, like and subscribe !.

All of my uploaded material is protected under copyright law. None of my videos may be re-uploaded, reproduced or transmitted, in part or in full, in any form or by any means, without the written permission of the copyright holder.

Read important information below:

Disclaimer

Due to factors beyond the control of Screwsnutsandbolts, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Screwsnutsandbolts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Screwsnutsandbolts recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Screwsnutsandbolts, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Screwsnutsandbolts.

[Predrag.Mihailovic]

Great job, great video! Thank you very much. I have a Citroen C4, but both cars are so similar, and I think the process is just same.
Thank again!

[markwilliams]

Brilliant! Just so tempting looking at the gearbox and thinking a few more bolts and the Clutch comes ! i Like the rubber Jack Pad with the slot.I made mine with an Ice Hockey Puck that I found at a Car Boot Sale.Best Wishes and thanks for sharing.M

[luismejiaramirez]

Excelente video. Debo cambiar este soporte y ahora se como hacerlo.

[Muhammad]

Thank you very much for this video.Great job, I didn't know where this gearbox was. I think this piece is to origin , sound and vibration in my car?

[Sonego]

Hello, great video🎉
do you know if Gear mount
of the vehicle citroen ds4 so chic 2013.It's the same as in your car?Really similar
Thank you very much !😊

[shazdylmat]

Great video thanks, would this be a similar process for a Peugeot Expert 2004?
Got an advisory on my mot now it’s playing on my mind

[dracony]

Could you make a video about how to change the engine mount under the engine theres the lower one just right under it😁

[cyclingserbia]

Hi, I have replaced my 307 side and rear engine mounts . Now I have engine vibration when idle. Do I have to replace this one too ? Thank you

[jimmytomkins]

that's the same old one back again!

[ParFektion]

What were the symptoms that made you change it?

[philipmaguire]

On peugeot 2005 307 1.6 Hdi how many mounts are their I see 2 only ? 1 drivers side and 2 under battery side

[philipmaguire]

Is rear peugeot hdi 1.6 2005 have a rear mount if so is that the gear box mount ?

[vonzipperable]

What is the specific torque 9:35 center nut.

[tvfk]

Where is location the gearbox mount at 206?Does anyone knows?

[ryba]

Mam pytanie jakie objawy były tej wymiany.