2007 - 2012 Nissan Altima 2.5 Liter - 'Dogbone' Engine Mount Replacement!

Показать описание

Welcome back everybody! In this video, we are going to show you how to replace the front torque strut mount for our 2007 Altima 2.5. This replacement basically involves removing two 18 mm bolts, but in order to get those bolts out, some other things will have to be moved out of the way. That includes the strut tower bracket above the back bolt, in order to pull the bolt out, that will have to be pried up out of the way. The other bolt requires you to move the power steering fluid reservoir out of the way to gain access to remove the other bolt. All in all, it can take about an hour to replace. Enjoy!

Comment below if you have any questions!

Video Gear:

As an Amazon Associate, we earn from qualifying purchases.
We get commissions for purchases made through links in this post.

Disclaimer:
Trick Shift Garage hosts are DIY (Do IT Yourself), not mechanics. Due to factors beyond the control of Trick Shift Garage, we cannot guarantee against improper use or unauthorized modifications of this information. Trick Shift Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Trick Shift Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Trick Shift Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Trick Shift Garage.

#nissanaltima #enginemount #replacement

Рекомендации по теме

Комментарии

As of now how good is that engine mount aka "dog bone"? Is it worth buying? I just recently went to a dealership and they were going to charge 300 to replace it. I am probably going to do it myself, thanks to your video.

AznBoyz

Thanks for the video bro went to the dealer and they wanted to charge me $518. I checked out your video and did it myself for $69 took me less than 30 minutes!

THESSTER

Torque specs for both of these bolts are 63 ft-lbs according to manufacturer's service manual. Stubby 18mm socket with long reach ratchet helps very much for this job. Can be done in under 25 minutes.

danielteixeira

Trick shift garage baby!!! Thanks for the vid will try this soon

thecoach

hey boss man . what were the symptoms of the vehicle ?

was it rough idling ?

the wheel shaking when braking ?

things like that?

levisluv

Any plans to make a video on replacing the lower/rear engine mount? I did it a couple years ago and the aftermarket part already needs to be replaced. It was a major pain so wondering if you could show a better way 😎

tribesascendvideos

Nice video very helpful by any chance do you have videos on replacing the other mounts?

axelbalderrama

Thank you so much for your video :) what were the symptoms before replacement? Was it a rattling noise when you came to a stop ?

faith

Any suggestions on what to do if the horizontal bolt does not line up with the hole in the block? After lots of trying I just put the old one back on so I can get to work tomorrow, and it lined up fine for that one.

xTheAnalogKidx