DIY 40000mAh Super Fast Charging PD Power Bank

Показать описание

#SuperFastCharging #PowerBank #ErCanEverything

⚡PD Fast Charge 5A 100W Type-C USB Charging Module

ErCan Everything

Рекомендации по теме

Комментарии

Bro you could have done the screw system because in further anything happened u could have opened and it would be easy to repair. This was my suggestion that's all

shreyassairam

YESS FINALLY SOMEONE WHO SPOT WELDS AND NOT SOLDER

pekhejdj

before anyone makes this battery, if you intend to bring it on a flight, this battery would not be allowed as the maximum capacity allowed on board is 100Wh. For standard 3.7V li-ion packs, that's 27027mAh.

voxpop

battery pack is connected in the form of 5S 2P so the maximum capacity is 7.2Ah (if the capacity of each battery is 3.6Ah - the highest capacity for 18650 battery) cannot be up to 40Ah as the title.
If it's 40Wh it's entirely possible.

kebian

You should use higher gauge wire for battery terminal connection

WALKER

Я аккумуторы обычно на автомобильный герметик фиксирую. Держит ни чуть не хуже чем заводской компаунд

AntonKhabarov-sv

I like to make this bower bank but unfortunately it is not available in my contry this module but allready i ll made power bank and i make some projet by arduino and raspberry pi, have a nice day 4 all, 🎉❤ good jop, thank u

AOBAboOmer

There ain't no way that is 40, 000mAH. You'd need 12 batteries if you could find 3500mAH batteries. But as most are around 2600, you'd need 15-16 of them.

stoojinator

What is the difference between parallel and series in batt? Thanks for your help ❤

betch

Ladko nai saman banaya hai or
Ladki nai ladko ko pagal banaya hai
😂😂

ShivamAgarwal-kw

When I read carefully the video's title then I just 💀⚰️😐
And when I saw the pcb you use then I live longer ❤

😂😂

Itz_Rai_x

Ummmm about the battery’s they will charge each other if they have different battery levels and that normally is fine but they can’t limit how fast they charge, they over heat and eventually they go💥💥💥 a good way that never fails to solve this is to put
Resistors On onside of the contacts that will slow the speed to an safe level

zisenwang

Low heat dissipation.
Low maintainability. it needs latches or screws.
Low safety of touching the contacts of the circuit on high-current elements. in this case, it is possible to shift the elements in the adhesive layer.

And make rounding on the body! brick is not too aesthetic.
For the rest - the combination of individual elements of the scheme is good.

Sangre

Dari mana anda dapatkan modul itu dan kenapa ada port tab c di modul nya sedangkan baterai yg di rakit 3s 8cell. klo baterai secara di seri 3.7 volt menjadi 12volt

topanraditya