1.1.7 Packet Tracer - Basic Switch Configuration - Physical Mode

CCNA Switching, Routing and Wireless Essentials v7.02 SRWE - 1.1.7 Packet Tracer - Basic Switch Configuration - Physical Mode

[dc]

Just is as if it gets stuck at 96%. What I did to get to the 100% completion I saved all my work and closed the packet tracer. Then I reopened it as if I was going to make changes and it showed that I was at 100% instead of the 96% that it showed before. Hope this helps anyone else watching this later. Thank you Christian for the video and the ones you will continue to do.

[abagail]

You have the BEST tutorials, you have taught me more in the last 4 years than my paid instructors. Thank You

[david]

Christian, you're the man! I am studying for my CCNA at University. Please continue to make these videos. You have a new subscriber!

[normdeplume]

thanks Christian this is the only tutorial which is up to date with the current SRWE course

[ndohcollins]

Mr Christian this is really a fantastic job: well explained, well understood, and well explicit, pls continue, switch configuration on a trunk.

[joec]

Thank you so much for this. You help me so much more than my online teacher.

[stevem]

Hello Christian!
Thank you for all your hard work, I wanted to send you a comment before. I subscribed to your channel today. And I owe you thank you for all you do for the Internet community. Thanks again!

[Stmi]

Hey I can already tell; you videos are going to help me so much more than my teacher of Cisco II is... so thank you thank you!!

[scottb]

Thank you for the video! Keep them coming, please.

[CaliKPC]

Thanks Christian! I went to bed last night at 96% and when I woke up and loaded the PKI file it was at 100% and I hadn't changed anything. It had the same error you had at the end. Not sure why that happened but it worked.

[xxdavidxxyt]

I can´t thank you enough... thank you professor Romero.

[fodecissokho]

Thanks man !! you are killing it
Eveything is well explained .... keep it up G- 🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥

[stokes]

Definintely earned a sub. Thank you for the help and the walkthrough.

[ucambo]

Thank you for sharing your knowledge Christian!

[camilaaltamirano]

Christian thanks a lot men, you are helping me to get trougth my CCNNA certification

[dandoapp]

Christian, you are a Genius my friend

[thecreatornooj]

thanks so much, my professor isn't really useful for this kind of help, and meandering through the modules alone wasn't working for me either

[Yiyex]

Hi! before any question... jus say what an incredible help this is for me and many others that stumble upon your content. Very much appreciated all the efforts that you put out in this videos.
Now my question: In this video, you checked the vlans and the vlan 99 was in the list with the command "show vlan", why you have to create it with the command "vlan 99"?

[AdreetoShowmik]

when i reached the terminal at part 3 it asks password after s1> enable the password should be cisco as I set it. but it is saying bad secrets. HELP

[chrisaelus]

stuck at 96%, i checked the results and it shows the FastEthernet0 having an "X" mark on IP Address. how would i reconfigure this?