How to Use/Apply Plastic Wood Filler Hole Repair Dap Fill & Re-drill

Latex Wood Filler Plastic Wood How to Patch or Fill Wood #DIY #dap #woodwork #woodworking #wood #dap #plasticwood

Plastic Wood Product Can:

Plastic Wood Product w/Drydex:

Plastic Wood Product Tube:

Plastic Wood Product Bigger Tube:

More Videos:

Check out my Merch Store for T Shirts, Hoodies, Tank Tops and More!
Click the link below:

Contact info:

Disclaimer:
This video is for entertainment and or informational use only. What The Fox (Sherri Fox) assumes no liability for property damage or injury incurred to oneself or others attempting to perform or recreate anything contained within this video. What The Fox (Sherri Fox), does not guarantee against improper use of this information. What The Fox (Sherri Fox), does not guarantee or warrant any particular results as seen in this video. What The Fox (Sherri Fox) recommends safe practices when working with any tools or equipment as seen or implied in this video. Any injury, damage, or loss that may result from improper use of tools, equipment, or any information contained in this video is the sole responsibility of the user and not What The Fox (Sherri Fox).

#whatthefox

[TheOfficialFoxox]

great video, loved the music too, thank you!

[jasonlachance]

really good video. It's what I was looking for

[blindluck]

I have done this before. I added some stain to a small amount of the plastic wood and put a smear of it on the word. Let it dry and if it needs more stain, add a little and do it again. When you get the correct amount of stain then go ahead and fill your hole and sand away all the other stuff. 3:27

[henloco]

Maybe could drill holes bigger and use dowel rod for plugs? And glue of course

[jasonspies]

To make the area match much better with stain application, take a wire brush and lightly brush over the area in the same direction as the grain once product is 95% dry, it will help sell the look as long as the colour is matching with the natural surface. Becarfully not to over apply pressures as it will cause damage

[libbystevens]

I always enjoy your videos! Only wish you posted more! 🤪I can’t ever get my stain to match the color of this filler for some reason. Not sure what I do wrong.

[ifimust]

What was the purpose of staining first if you sanded off the stain?

[mikeheroes]

When dealing with a 1/4 inch screw hole in a wall I’m thinking a combo of matchsticks, toothpicks, wood glue and wood filler in the deepest portion, jam it all in there as deep as possible, and then a wood dowel covered in both glue and wood filler shoved in last and hammered in to be flush with the wall, then one last scrapped layer of wood glue and filler. Let it dry, and bing bang boom my stripped wood hole is ready for me to fuck it up again with too much torque

[mijeightyfour]

Thanks for the video! Any idea what the best method is for filling screw holes that are 3” deep? At that point I’m not sure if this type of product would be best, or maybe a wooden dowel. For the dowel I’d have to drill the holes a bit bigger and I’d rather avoid that if possible.

[claudiathomas]

Add some stain to the product before filling/applying so it matches as close as possible!? 🤷🏽‍♀️

[daledorsett]

Apples and Oranges. The plastic is resistant to staining, highest probability it will never stain to look differently. If it were paint it would cover it up bu the nature or stain is based on absorption of the stain.

[DavidRitko]

I would just use wood glue and toothpicks