milling an awkward stump

This stump was too high to put on my sled router table so I had to take the top off ith my chainsaw mill. I usually use a ladder but this time, it was easier to screw a 2 by 6 on the stump. I had to shim one side as it was considerably lower than the other side. I then adjusted the mill to cut below the 2 by 6 AND the streaks that i streaks board. That last step is important as the screws are super hard and will ruin your chain.. possibly your day as well.. If the screws are 3", mill at least 1/2" lower to make sure you don't hit them. When the mill height is set properly, turn the chainsaw on and give er'. I am not even sure what kind of wood this is but it's one less weird stump in my garage!!! The rest will be flattened on my sled router table.

Milled with @stihlcanada #ms661
@oregonproducts ripping chain and 42" bar

If you're looking for the same Oregon 42" bar I am using on my Stihl MS661, here is the link where I bought it on Amazon.

#milling #ottawamilling #howto #chunk #cookies #cookie #alaskanmill #chainsawmill #oregonproducts #smalllogs #small #slabs #slab #salvage #salvaged #weird #ottawasmallbusiness #ottawa

[youwillneverknowiamherefor]

If you continue to listen to this song I’m going to revoke your chainsaw privileges