How to make Automatic Irrigation System Using Arduino

I will show you how to build and implement an automatic irrigation system which can sense the water content in the soil and automatically irrigate your garden. This system can be programmed for different crop requirements and seasonal variations. This system is best suited for drip irrigation technique. I have also tested the system for different soil conditions and water availability.

This System will help you to irrigate your backyard Garden or your Indoor Garden automatically and you need not to worry about watering your favorite plants in your busy schedule.

Arduino UNO is the brain of this system and all the sensors and display devices are controlled by it. A Moisture sensor is used to read the Moisture content of the soil. An LCD is provided to monitor the Soil Status, Ambient Temperature, and Status of Water supply(Water Pump).

Please follow the following Instructable link for circuit diagram and Arduino code.

The above instructable is in gardening contest. PLEASE VOTE ME and it is highly appreciated! Thanks

Thank you for watching.
Subscribe for more project Videos.

[_nawazkapadia_dse]

Keep it bro uh helping many of people's out there❤️🔥

[maxxel_]

nice job! you should maybe make it so it pumps water for like 20 seconds and then waits a minute to read the sensor again since it might take a while until the water reaches the sensor

[TheRodeoRider]

Excellet bro.I have some doubts.1.Whats the use of speaker?2.If I have to use more than one soil moisture senser how can I connect them?

[charlesteker]

Hello, I was hoping that you could help me. I like your design, but I want to use a timer and have the moisture sensor as a safety. Also Like to add Co2 read out. Thanks in advance for any help. Skip

[pranav]

I have a dout about the circut diagram . Can you upload a video on circuit diagram of this automated water irrigation?

[kcsvlogs]

Hi good vedio bro..but one question..bout code ..from where should it downloaded and what should be required

[DeclanGreen]

Thanks for this project. I think I will give it a go.

[jadajayasurya]

Bro copper coin needle vdo rako na bhai

[filipinodiynot]

hi, thank you very much for your video, but do you mind if add pump runtime for 20 sec only then wait for 3 minutes to let the soil soak properly and run it again for 20sec until the sensor will be satisfied. thank you very much in advance

[karmathbhardwaj]

Can you let me what if we went out for few days
Will it work autometically

[amierullridzwan]

Hye can i use this for 2 horsepower water pump?

[dailydose]

Sir I have an issue in the project
My pump doesn't turn off after placing sensor in water 🥺🥺🥺 I have done all other work

[bongukusumasri]

Can you please give complete details about this project

[dibraniuk]

hi, good project! can you share a link to the float switch sales? thanks

[lusklourin]

There is no code for ardunio bro In the link. There is only hardware details

[bhavyasrivastava]

sir please can you explain the significance if LM393 in the system above

[satabdipalit]

Hello sir, can it be implemented in real garden. If yes den what should be the motor capacity.

[metalalive]

Good job man, Where did you get your water level sensor ? (from any online shop maybe ?) I'm looking for the one with reasonable price.

[clashingcommando]

Please make a video on wiring on Perfborad of this project

[pavanhv]

Bro I am not able to code it please help me 🥺