2003-2007 Honda Accord - Wheel bearing replacement

[charleslavell]

Great video, got it done. I bought the whole knuckle assembly with wheel bearing already pressed in with bottom ball joint. I think it was easier and no hydraulic press to worry about. 3 nuts and axe nut and ABS and brake line bolts. Watching video helped greatly, Thank you!

[Desertkitfox]

This was a super handy video. Thanks for taking the time to film it. I appreciated the step by step instructions, and the torque specs.

The bottom ball joint on my 07 Accord gave me a fit. I ended up using a floor jack (with a piece of 2”x2” wood) to push upward on two lug nuts while compressing the suspension. I used a sledge hammer to hit a piece of metal rod against the lower A-arm, and the ball joint finally broke loose.

[spelunkerd]

Nice demo! It's taken me a few years to understand how these old style pressed-in wheel bearings go together. The reason the bearing consistently breaks apart in two pieces is because the snap ring prevents the outer race of the bearing from coming off when you press out the hub. The snap ring is shielded by the rim of the hub, so you can't remove it, or even see the snap ring until the hub is removed. So, after a few years the inner race ends up being seized on the shaft of the hub, and the weakest link ends up being the bearing cage. You did a great job getting the inner race off the hub with the Dremel. I've seen other guys use a torch to expand the inner race, causing it to fall off without using the dremel. One day I'll try that.

[adamnathanielbassett]

I would have replaced that lower ball joint with that torn boot while you had it off. It will probably fail soon...

[alaaa]

You make look easy but I know it is not. Excellent video. Ty for posting

[alphadog]

7:40 DAD better not leave young lad hangin'...you're needed

[ehanson]

Thanks. I like your use of fast forward.

[americafirst]

Good video. Was curious if this job is possible with wheel bearing kits or is a press needed?

[_RedsTech_]

Is it possible to replace the brake shield without removing the hub?

[christinamccoy]

What tools do I need to change this part in my car?

[silverc]

i did this on a 2016 honda accord sport and now i’m driving with a bunch of lights on my dashboard. do you have any idea why this might of happened ?

[alphadog]

I am replacing every damn thing that looks bad...get all the birds stoned at same time

[joey]

hey if i hear humming noise and it’s my wheel bearings should i replace all 4 then ?

[synovium]

Everything looks relatively easy to me except when you get to replace the bearing. I, unfortunately, do not have the luxury of a hydraulic press. Therefore, what do you suggest as the next best option?

[Eashlo]

Is it easier to just get the wheel bearing hub assembly so that you don’t have to deal with removing the old bearing?

[bon_vieira]

Where did you place your jack stands? Manual says to use the spot behind the front wheels (where the scissor jack would go) but my floor jack wont lift up the car high enough that I can put stands there at a good height. Thanks!

[billydoan]

Where did you get the tool to press the wheel bearing out

[dominicwalker]

Good day! I want to know what is the number of the bearing that is used on a Honda accord 2003 cm4 model. I am trying to find it in amazon

[MrSupernova]

I have an '08 Accord. Do you know if I need to remove the dust shield in the back or inside part of the bearing facing the axle? Thanks!

[furia]

Could you put the data of the parts you changed?