How to Replace Front Wheel Bearings & Hubs 2003 2007 Honda Accord

Buy Now!

This video shows you how to install new front wheel bearings & hubs on your 2003-2007 Honda Accord.

Estimated installation time for a professional technician is approximately: 4 hours 6 minutes

This repair was done on a 2006 Honda Accord EX 2.4L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
2003 Honda Accord
2004 Honda Accord
2005 Honda Accord
2006 Honda Accord
2007 Honda Accord

🔧 List of tools used:
• 19mm Socket
• Press
• Snap Ring Pliers
• Wire Cutters
• Ratcheting Bit Driver
• Swivel
• Copper Anti-Seize
• Rust Penetrant
• Safety Glasses
• sanding disc
• Sandpaper
• Hammer
• Wheel Chocks

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[AAuto]

√ Watch the Video
√ Do it Yourself
√ Save Money

[tacosanloresno]

For the DIY people who don’t have a press. You can buy the press or a bearing and hub removing kit. Both theses kits can be rented from auto stores. I’d recommend the slide hammer to remove the hub over the other tool. Remove the hub and bearing while knuckle is on the car then do everything else to take it out. After it’s out take the knuckle and new bearing and hub to a tire shop, they should be able to install it. Prices will very by your location and shop one shop quoted me $65 per knuckle another $25 it depends. I went with the $25 and they did a great job. Then just installed the knuckle and everything back together.

[johnchambers]

Nice video and very descriptive on the process required to do this job.

[tootsrr]

Wish all the knuckle joints I have worked on would separate after 2 bangs (even after 20 bangs & a lot of #%@#) with a big hammer using a knuckle separator you have to be very careful you don't destroy the rubber grease cover 1A Videos are great

[franciscoramos]

Once tried to squeeze a shortcut in, I swapped the rubber for something use I grab from the junkyard. Biggest mistake. I had to runback and forth a day before my return to job. Almost didn’t make time.