Craftsman Ball Bearing Tool Box Drawer Installation Instructions | Slider Removal & Install

This is how I got the drawers on my Craftsman ball bearing sliders to go in. I removed them when I moved and when I went to re-install them they would not go in correctly. I show you how to install the Craftsman drawers. Once you see it done it's not that hard.

#sears #craftsman # help

Proudly Made in the USA with Global Materials in Sedalia, Missouri
BUILT TO LAST: 18 – 20 Ga. steel I-Frame® construction
FULL EXTENSION DRAWER SLIDES: Support 100-lbs. of product
LOAD RATING: 1,500 lb. load rating with 5-in. x 2-in. casters
SURFACE PROTECTION: CRAFTSMAN®® embossed top mat protects surface on top of the rolling cabinet
SAFEGUARD YOUR TOOLS: Keyed internal locking system safeguards your tools
14,062 cubic inches of storage
Assembled Dimensions (WxDxH) 41 x 18 x 37.5-in.

More About BundysGarage:

Questions, Comments, Concerns:

Twitter:
@bundysgarage

On The Web:

Music by Randall Kent: As seen on NCIS

All Rights Reserved 2019
© Copyright 2019
Bundys Garage

DISCLAIMER - DISCLAIMER - DISCLAIMER

Due to factors beyond the control of BundysGarage, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. BundysGarage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. BundysGarage recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of BundysGarage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the end user and not BundysGarage nor any of it’s subsidiaries.

[corrieziegler]

where can you buy the slider replacement parts?

[EliseandDanchannel]

How did you get the draws out of the sliders. I have what looks like the same sliders and I can figure it out. Mine do not have the little lever on the side as some do.

[kenbred]

You should mention to your viewers, that if you are replacing the slides, that you can't use just any old slides. The tab that you mention at the top front of each slide is what your drawer locks into when closed. No tab on your slides no lock for your drawers.