Float & Set Full House Bonding Beads and Skimming Ceilings part 3

Full new house to be sand and cement rendered aka devil floated and skimmed out ( float & set ) #floatandset #plastering #vlog
popular diy, plastering and rendering videos on the channel

How I Render Brick Walls Outside Exterior cement rendering acrylic
brick effect render
Dec 2019

microphones used =

All amazon links are affiliated links will cost no extra to buy from but we might get a %

tools links direct

How to sand and cement render concrete block wall 1st coat scratch coat DIY

Find us and like us here

Tweet us here

[durexjim]

Great to see a proper spread using a spot and stand great job

[ForensicCats]

Mac, youtube was not sending me your content, I just had to search for it! Nice to see you buddy.

[darrenwatson]

First class floating there mate, top spread👍

[SirTerabyte]

You make it look so easy and I know how difficult this is. Well done mate!

[RailsandSky]

You're an absolute treat to watch. Best wishes from Ballyhenry Road.

[markhep]

Mate did a bit at weekend haven't done it for ages near killed off 😂😂😂Nice vid mate 👍👍👍

[paultant]

Great video Mac. Showing a lot of your builders crack and teesthirt on inside out. Must be busy. Not a spread but have done some. Do you use joint filler on scrims and leave for a day and also how much skim do you knock up. Looked more than one bag on that spot board ?. 👍👌

[brimplas]

Another good video pal 👍. Is the render pulling in the same as the plaster board ? I hate skimming backgrounds with different suctions !

[pain]

what kind of plaster u using ? its so creamy...you puts some dishwasher?

[squidlings]

1:00 camera tip... See how the window is in the shot... Its blowing out the picture, so where u are is darker. If the camera was the other side and the camera man had his back to the window. The light will shine onto the wall and you... The camera struggles with high light and low light in the frame. (hard to explain but next time you film try it out. Keep your back to the window where possible and then your using the window light to your advantage because its shining onto you without blowing out the picture)

[emmettmccarthy]

Great tip there always and I mean always coat out Ur skrims and door frames, beads etc first.so much easier when it comes to flattening, here Mac what make superflex u think is best, need to get a new 1, nice job as usual 💪