How to use Infinity CM2 MTK to flash Mediatek firmware

This video explains how to use Infinity CM2 to flash firmware to a Mediatek (MTK) device

Its important to only flash firmware for your device to avoid bricking it

Drop a comment below if you have questions or reach out to us on the following platforms:

00:10
In this video tutorial, I'll be explaining how to flash a Mediatek Android phone using Chinese Miracle 2 MTK

00:18
module. You need to have the module which you're going to be installing and the firmware which you're

00:27
going to be flashing. I'll be flashing in scatter format as you can see. You should also have your

00:34
VCOM drivers installed, we have a guide on how to do that so check that out on our Forum.

00:39
Now, once you've done that, install this CM2 MTK module. You should have the hardware dongle

00:53
on standby. If possible, you can have it connected to your PC while you're installing the module ok?

01:02
So you don't forget to connect when you launch. [installing both MTK modules]

01:39
Now, make sure your dongle is connected to the PC's USB port then launch the Infinity CM2 MTK shortcut.

01:52
It takes a while to come up so just be patient alright? Now, select your phone's chipset

02:11
under Settings - CPU. We have a guide on how to know your phone's chipset. Now, once you do that,

02:16
you go to the flash tab. Depending on what you want to flash (bin or scatter format), you tick

02:23
the appropriate radio. I want to flash in scatter format so I'm going to be ticking scatter.

02:29
Now, under Settings, you have some boxes. I'm going to untick everything. You can decide to tick any.

02:38
Once you're done with that, you click on Scatter and then a Window should popup. Now, in this Window that

02:45
pops up, navigate to the location where you have your firmware / rom which you want to flash

02:53
then select the scatter file and click on Open. Now, the firmware / rom should get detected.

03:02
Now, click on Flash and you should have ====Wait for phone.. Power off the phone. still with battery inside

03:18
then connect it to the PC via the USB cord and you should have detection. Flashing should begin.

03:27
Its very important you don't interrupt flashing ok? Alright! Great! So flashing is done.

03:38
That's basically how to flash a Mediatek Android phone using Chinese Miracle 2 or CM2 MTK module. --------------------------
Hire Or Consult Us

Join Our Training

[al-ameenabdullahibalarabe]

Thank you guys with adding us more ideas

[EDDYYURDA]

How can I flash a tablet that's in a bootloop and the bootloader is locked and the adb is unauthorized? How can I do that with a tablet

[emojeljohn]

Can i use it on these Nokia android phones???

[hahahaha-dfvm]

it wont open, it did not show when I clicked open