The BEST Way to Bleed Your CLUTCH! Ford Focus & ALL Other Fords!

preview_player
Показать описание
Yeah, I know, inflation happened. It's $100 now
Рекомендации по теме
Комментарии
Автор

This comment section is off the chain! 😁👍

Michael_J_M
Автор

Can you vacuum bleed out the air from the line as well?

phordguy
Автор

Question: No DTCs, 2012 Focus, I took my car out yesterday, and 2, 4, 6 gears were missing. I turned the car off, restarted it, and they were shifting normal again. Same thing today. So this is intermittent without and codes being thrown. I performed a clutch actuator test with my scanner, but it would not complete and said "clutch position ramp loop failure." Where would you go next in the diagnostic procedure? Have you personally come across this issue? Obviously, I am thinking possibly TCM or actuator starting to fail, but... Thank you, Ben!

Nothingman
Автор

Hello! I have a 2014 Ford Focus SE Hatchback, and I'm having trouble with the fan not coming on, I replaced the fan with the control module and
temperature sensor, tested the relay and the # 32 fuse and all ok, any advice would be appreciated.

rm
Автор

i have codes p286f and po7a3 car will not start unless in neutral. terrible shifting in 1st gear, slight jerk in 2nd gear, will over heat in 3rd gear and will not shift. In limp mode and no power when accelerating. any help?

oldxoul
Автор

You would think Ford engineers could design a simple way to bleed a clutch in a Ford Ranger. If you put a bleeder on a system, it should work! But it doesn't. And even having the throwout bearing in the bellhousing is a stupid idea. So I just stop putting clutches in Fords all

ddyeo