Creality Ender 5 S1 3D Printer Review - WildRoseBuilds

Claim Code：15WRB1430

Claim Code： WRB15

*Special thanks to Sainsmart for sending this machine in exchange for an honest review.

Models:

Tronxy tricolor filament:

#3dprinting #timelapse #wildrosebuilds

[minmaxwax]

Enjoying your content! I’m also biased towards the wild rose and the specific mountains in your logo. Hiked 2 of them 😊

[hexesandheroes]

I've been running the PC build plate on 3 printers for months and after it has like 20-30 prints run on it parts pop off just by curling the plate corner. It is a good surface and I recommend it. Most of these reviewers never use it for more than 1 - 2 prints and then declare it sticks too well. After hundreds of prints I can confirm it works well, adhesion is great and its easy to clean. It also doesn't release if the bed cools. I have zero damage on them and just use my finger nail to remove the skirting.

[kiyan]

Just picked this up for under 300, it was about 20 bucks more than the ender 3 s1

[PimpnBass]

At 4:44 to 4:46 there was a print failure that was attempted to keep out . I seen it tho. I was looking into getting this one cause my buddy just got the ender 3 V3 Se. still in the air on it . ANd just to let others know that the sonic pad does do an amazing job also

[arfifteen]

This vs Sovol SV06 plus. Which one is better?
Thanks in advance!

[unlock-er]

Hiya, I tried printing this with brim and organic support, it turns out quite bad when it's done. it became too sticky. But if I print without any support nor brim, things came loose...just wondering if you're able to give me some guidance of what I might need to do? my kid wants me to print one 😬 ( i should've said the dragon)

[caeryllium]

"4" (si) in chinese has the same pinyin as death (si).. at 4:44 the print died

[airmanradar]

Anyone knows, how to stop calibration before each printing? Is stupid, the printer waits to warm up table and extruder, then starts calibration process while temperature is droping, after its done, then warms up again to begin printing. What a waste of energy and time ! How to disable thins in Ender 5 S1 ?

[TomShelvey-gcbe]

3 times advertized just like this is 2 or 3 times gaster than tje rest of the pack as advertised?

[miku-hole]

新影片！ya new video
創想3維的ender 5 s1
04:44 死了！Damn it!

[stanleyhoptroff]

this printer dosent make much sense when for an extra 100 dollars you can get p1p

[CincyNeid]

Creality can barely make a Marlin Config file that works correctly. And Klipper is still technically in Beta.... I have a feeling the K1 will crash and burn.

[ltraltier]

The ender 5 pro is hot dogshit. Get this instead.