AC servo controlled with Arduino

[kylanjohnsonmusic]

Hey there! I really enjoyed your AC Servo video - it was super informative and well-presented. I'm working on a similar project and was wondering if you'd be willing to share the schematics you used? It would be a huge help in understanding the setup better. No worries if not, and thanks either way for putting out such great content!

[weatherwatcherph]

Hello, what AC servo did you use for this project? I'm planning to build a boom barrier this upcoming summer. It would be a great if you have any suggestions :)

[matthewcuasay]

Im having troubles identifing the right configuratiin of wire😅. Can you share the wire diagram especially on the connection of the input output connector

[dougmacqueen]

Is this to be used for dial combination locks?

[andreklarenbeek]

A wiring diagam and code would grately appreciated..

[muhaiminalthaf]

Is this PWM pin connecting to arduino pin?

[aesopp]

Did you set any parameters or setup in the motor before running the code?

[RC_Club]

Thanks so much for that valuable video but I Know that Arduino cannot be used for industrial applications like working 7/24
Do you any microcontroller that is destinated for industrial applications!?

[DammikaLansakara]

Hi!
I have a Berger Lahr Model VRDM 3913 LNB & VRDM 366/50 LNB Servos.
But I don't have a good knowledge of how to operate these and also how to identify wires.

Could you pls help me to give it a start.
I have a fair knowledge of Servo Motors and Arduino.
But have no access to relevent literature re. Subject matter.

Kindly be good enough to direct on setting up the same.
Gerald

[Rinaldocr]

ola, sou do Brazil. poderia disponibilizar o diagrama da ligacao do Arduinno

[somestudent]

are pins 13 and 11 connected to DIR and PUL?

[mitko]

Hello, is possible send or sell wiring diagram and Arduino code?

[ПандаКарвингООДГаброво]

Hello, is possibility send or sell for me wiring diagram and Arduino code!

[vijaykarthi]

Hello sir i need a connection diagram, to control servo motor

[duyo]

Hello, please give me the code and wiring diagram

[andypughtube]

A long while ago I used an Arduino to measure the position of the resolver on a servo motor for commutation and then control the H-bridge of a power IC.
this is a bit like your setup, but without the commercial servo drive.

[tarehjernetarehjerne]

Hello folks, somehow this video got a lot more traction than it should. In 3 days from aug 9 there will be a wiring diagram here:
I do read comments!

[basketballjones]

So, you're controlling the AC servo controller with the Arduino, not the AC servo motor. Here's a thought: Be accurate in your video descriptions so you aren't just one more jerk adding to the noise, making it hard to find the info one is actually trying to find.