How to use a Torque Wrench

How to properly use a torque wrench. You use a torque wrench on nuts and bolts to make sure they are tightened to the correct torque. The units are Newton meters or foot pounds.

[Ghengis]

Thank you for a short, simple explanation, ... without a 10 minute introduction all about yourself.

[TVD]

1 minute, 53 seconds. No waffling on, just exactly what you need to know. No filler. Many thanks. I wish all videos of tools on YouTube were like this. Can you imagine the time you'd save!

[bigbopete]

Cut, dry and no chaser. No theatrics, just dropped the knowledge and it was a done deal. Class is in session.

[jonnyvegasxd]

Oh my gosh dude I watched three other videos in felt more ignorant about this after watching them, yours was very simple and to the point. Thank you!

[ivanwill]

Flipping heck, brilliantly done! I watched other videos about this, and thought I was losing my mind. Thanks for sharing!

[SandStormPower]

Straight to the point. Thank you! Never used a torque wrench and this was easy enough to understand how it works.

[slickvic]

This is what we are looking for, an easy to follow explanation without all the crap! Thanks for the great video!

[crumpeteer]

Great, just what I was after. A plain & simple tutorial. Thank you Mark

[ichigokurosaki]

Best explanation ever thanks for posting.

[jhm]

Simple and easy to follow instructions. Thank you

[Nico-ynvg]

Short and to the point with no extra info is much better . I watched 2 other videos and still didn't know how to set a torque wrench. I watched your video and I do now. Thanks!!

[NoName-ispy]

Have torque wrench in my garage, never used it before, after watching this video I'm going to use it every time.. Many thanks.. 👍

[ALKUKES]

Very simple and easy to understand, one question how do I know for each and every single bolts on my engine torque specs? Thanks for the video

[russellbutt]

This is great but it's really hard to see the numbers on the right side - ie where the 112 is - due to the reflections. I'm struggling to see if I need to tighten to where the line for the correct torque joins the centre line, or do I torque to where the line sits under the actual number??

[edmundochavarro]

Thank you for that video, straight to the point. Other videos were 8 to 10 minutes long. This one was perfect

[rcsciontc]

Perfect. You make the instructions look stupid. Thank you so much for this post.

[saudade]

Did you know? You got straight to the point. No one else pointed it out so thought I'd bring it up.

[Wicked_He_Bad]

Short simple to the point and very well explain

[stendecstretcher]

Your demonstration is the easiest to understand thankyou.

[Fricer]

Had to make sure I knew how to properly set this, did not know that the numbers next to the 0 were just added to whatever the set number is. thank you.