Plasticity 3D Tutorial | Spray Bottle Design | Advanced Surface Modeling (Quicktip18)

Plasticity 3D Tutorial | Spray Bottle Design | Advanced Surface Modeling
How to Design a Spray Bottle Body
(Quicktip18)
Free Bottle File:

[SalkovAA]

Very cool video. I have one question, when you close the hole with loft in the fifth minute of the video, you use two curves as guides, but after the loft, hard edges form on the surface in place of these guide curves. I repeated after you, and I managed to get rid of those hard edges, I used patch holes instead of loft, but that is not always possible. These hard edges do not spoil the silhouette of the model, at least the polygonal one, but the shading suffers because of them. Please tell me how to deal with those hard edges after the loft or is it unavoidable?

[MIchaelSybi]

You must have tons of experience, I really enjoyed the process and great model result

[seankelly]

This is looking very good. The fillets are amazing.

[craigwall]

It's obvious you have master craft skill. If you want to demonstrate your superior abilities...change nothing. If, however, you want to appeal to a larger audience and share knowledge...slow down the video...and try to communicate stages of development. Plasticity will soon explode in popularity. You have little time to choose a path if you want to remain relevant to YT's audience. The plasticity tutorial world is going to heat up fast.

[TT-rlsu]

Thanks for sharing your knowledge free.

[CarlosPrGr]

Just the process I was looking for 👌🏼😎

[Argyll]

As this bottle is basically symmetrical, do you think that perhaps a better initial approach would be to model half of the bottle then mirror it rather than do this later on in the video? To me, and I speak personally, your approach of initially modeling the entire bottle seems to complicate the process.

[dkiwi]

Very tempted to buy the studio license but have yet to see proof of .obj import?

[juanpaulomardonez]

Hey Chris, Which command did you keymapped to "D"? I cant find how to duplicate an isoparm or edge like you do... :)

[xuanfox]

I followed your process till 2:33, I lofted these 3 circles and tried to let the side curves as guide, but it didn't work at all.I checked many times, the circles were definitly linking with the side curves. I tried from scratch agin and again but it still didn't work.

[ТамирАлтантариа]

PLS can u teach some kind cosmetic product model