Fusion 360 Basics Webinar - 8.10.16

[xjstevie]

you forgot a couple things... the rotating shaft should have thread in the main body so it can go up and down and the slider should be connected to the shaft... thx for a great vid, learnt a lot

[WisdomVendor]

I think when you 'pressed' the screw to a smaller size, it mage the top of the screw which you used revolute on nonconcentric with the screw. The top seemed to wobble during animation @47:18

[hlavaatch]

When you mirrored the left half of the handle with a thread you created a left handed thread on the right side - not something you wanted i guess :)

[vangalvin]

This nearly solves the problem i have been having, I am trying to do something similar except with a thread and instead of have the shaft just slide up and down have the handle rotate, the shaft rotate and push the die down.
Would love to see if this can be done as I have had no luck so far.

[DougHanchard]

Holy smokes. Lots of steps to learn for the novice. Deep dive! The construction plane was interesting. Is it possible to create two control movable control planes (say x and y) along the length of a rectangle box in order to create centers over multiple cylinder holes?

[MondoLeStraka]

I have the latest version of Fusion 360 2020. Is think some of the menu selections have changed slightly or have had selections added to them. TIA.

At 17:43 I use the same instructions But the grid does not appear.

[atexnik]

From this webinar I also learned about Base Feature, when I tried to Edit Sketches in the start file and found there is no way to do that. That's how I learned about the "isolated" direct modeling concept.

[atexnik]

At 34:32 it seems you're not starting at the mid point of the face. I would first Project the line to that sketch, and then snap the start of the line to the midpoint. That causes wobble of top part at 47:11 when rotating.

[collinchaffin]

I found this to be far from "basic". It made far too many assumptions that the viewer is not only already a design expert, but that they already have some design software experience as a prereq for this product and it is being marketed as the opposite - as a tool for new designers as a new direction.

[landlockedviking]

was the 800 lbs just picked out of the air?

[LuisAlbanes]

Excuse me what key did you type to get to the Model Toolbox?

[carloseduardoduquemartinez]

Hi mi friend how mechanical simulation

[mrmrmaples]

discusses a thing called rule #1 then rambles for 7 minutes before showing how to do it...