Stepper Motor - How It Works

How a Stepper Motor Works, basic working principles, driving modes and Stepper Motors Types by Construction.

Like my page on Facebook:

Add me on Google+:

[licenseBort]

This was the shortest and best exlained video I've seen. Thank you.

[TheKenjitamura]

Very easy to understand explanation with great visual demonstrations. Thanks for this video.

[edgeeffect]

Excellent video... I've watched quite a few stepper motor videos and this is the clearest explanation that I've seen.

[BhaarathRamesh]

Excellent explanation. Tomorrow I have my Mechatronics Finals, and this video saved a lot of prep time.

[lianakriebel]

Just what I needed: an animation. This makes much more sense! Only wish that there was a better animation of the hybrid, but you explained it well.

[minhhieuao]

best video about stepper motor i've ever watched, thank you so much

[altair]

This is the best explanation of stepper motor fundamentals on the internet. Thank you very much.

[JShel]

Best stepper motor explanation I've ever watched. Very good, subscribed.

[ShubhamMishra-ijvg]

best introduction for any type of stepper motor keep it up

[AravindShesha]

good job Dejan, the topic is now clear, thankz....

[tonysfun]

Have you made any updates? Are you planning to improve the older design? You are very smart ingenier and I like to thank you for all you have done!

[TeacherictAu]

A very good explanation - Good graphics, and easy to understand. Well done!

[MohsenRasuli]

Hello. I just want to say thank you. you are very good at explaining

[richardbenes]

Great video, everything explained. Thanks!

[keethfrancmalcolm]

That's amazing. Thanks you very much. 😍

[vikyjene]

Thank you so much. Your explanation is really good

[zymantasdapkus]

3:50 phase letters on windings are mixed. Should be A, B, A', B'

[tiemze]

very easy to understand. Good explanation

[victorreppeto]

The hybrid motor came very close to answering my question but not quite. If you pull the rotor out of a stepper motor Karma you will notice that there are several rows of magnets. Instead of one long magnet per pole, each magnet is cut into several small section and each section is rotated on the shaft so it is offset just a little from the sections next to it on either side. I think I know why but I would like to hear it from you. My question is how do I calculate the proper amount of offset for each section?

[bhaveshnaidu]

Sir thank u very much for explaining it in such a simple and fast way