Servo motor control using STM32 and PWM || HAL || CubeMx || Keil

________________________________________________________________________________________

________________________________________________________________________________________

******* SUPPORT US BY DONATING******

*******Join the Membership*******

[ControllersTech]

To download code and for more explanation, visit the link in the description

[MIXTLI]

Thank you, I followed your instructions to program a F103C8.

[adihodzic]

Great video, but how did you get ARR value (1000)

[lilposte]

Great channel . Big thanks bro you really help us

[samsonk]

I will start using this for my robotics project

[sivapraveens]

Thanks for sharing, can u please share the details of that digital oscilloscope compact?

[mann]

Can you tell me on which PWM pin of STM is the signal pin for servo attached??

How are pins connected to the servo with stm pins?

[nhatduyhuynh]

i follow your instruction but servo not run. how you config analog pin ? show help me

[Akash-mc]

Sir, i am using f411re and i have set it to it's max clock frequency of 100 Mhz. What values should i give to the prescalor and counter period ?

[kpsplash]

Thanks for your video!
I have a question.
What do I have to do if I use a sensor from which get the angle of rotation of the servo motor?

[encryptedchannel]

3:27 you calculate the 45*10^6/50 = 900khz you get but your not written in the psc you just writing 900 but why, any formula is there for find out the timer frequncy

[mehmetdemir]

Hello, i cant use htim2.Instance->CCR in a for loop i dont know why help me pls

[last]

Do you have a video explaining the configuration for the comunication trow the RX and TX? Sorry for my bad English.

[siddhiparab]

Hii I have a question, do you have any idea how we can do servo motor on and off using uart protocol and USB to TTL converter??

[damnemo]

Hi, thanks for the video. One question, from datasheet this servo SG90 has operating voltage at 4.8-6V but you link directly to the pin of the stm32, How?

[thanhtaiphan]

can you control the motor by using potentiometer

[asilent]

how make the servo motor spin reversely?

[fabianhochstrasser]

Which Pin you use on the Nucleo Bord for PWM output?

[Abdulnur]

90 prescaler and 20000 ARR would also work. Is also 50hz

[alfian]

Could you give explanation for the schematic part (between mcu and motor)? i really need this