Hubsan X4 Pro H109S drone Calibration

#techreviewbyirdi #drones #hubsan
This is tutorial on how to calibrate the Compass and the GPS sensors on the Hubsan X4 Pro H109S. Remember that there are several calibrations to go through. And you can calibrate the GPS without removing the battery or disconnecting it. The compass will always come up when starting the drone and binding it to the transmitter since location direction is always going to be different.
This model has the low altitude version of the transmitters.

Filmed on the Samsung S6 edge

[MailonOfficial]

Very old video but good explanation.
If you can help me out with this question I have would be great.
I flew the same drone in the morning for 10 minutes, battery was fly charged. So in the afternoon I try to fly it again everything looked to be fine, before taking off, the drone just flipped down and it has the same message that you had at the beginning of your video.
Now I can fixed but was there any reason why the drone did that on its own?

[agentbertram]

Thanks for doing this. I was confused by the manual and will follow your set up procedure hopefully avoiding crashing the damned drone into a tree like I did last week.

[stefanlindquist]

Thanx sooo much, the manual some times confuses me;))

[raydesheles]

I habe the H109brushless I need to know how to unlock it I messed the controller up by pushing buttons or my kid did ??.please I can't get motors to unlocc

[rayhart]

It looked like you had the thicker 5.8 antenna from the drone on your transmitter ?.

[Luvovmoney]

hubsan h109s x4 pro check gyro sensor error, can you help me fix this.i cant start the motor or calibrate the drone.

[vicot]

Very clear and helpful tutorial but the reason that I am contacting you is because I need to know what version of firmware is on your drone ( Fc - Tx - Rx ). The reason because I am asking this is that when I buied the same drone (Hubsan H109S), it was flying without problem. Then I decised to upgrade the firmware but after that everythings went bad. I wasn't able to go out more than 80 meter whitout loosing signal and conseguential RTH. In your video I find out that you have the same firmware than I had before witch show the voltage of the Tx and Drone on the upper right side of the screen. I was looking around to find someone with the same firmware and asking the same question but no one write me back. Now, can you please, tell me which version is on yours so I can try to find and restore it on mine? Thank you for your help.

[chrisricotta]

Very good video but h109s is junk !! It's the only drone I have that I can't fly because it decides if it wants to go up or down and not cool with that .