How To: Bosch Dishwasher Panel Installation

This video provides a quick tutorial on how to install a panel on a Bosch dishwasher.

[jerryperullo]

One of the best how-to videos I've ever seen - because it is so short, to the-point, and doesn't waste your time on 2 minutes of soft music and personal intros.

[camelotgrace]

Such a great how-to video and exactly what I needed to reattach my panel, thank you!!

[harmonytrading]

Thanks for the video. Remember also that the template top may need positioning further down the door so to give the correct gap between worktop and door when fitted. It's not always the case that the template top directly lines up with the door top.

[karenh]

Great video. I wish the manufacturers instructions where just as easy!

[janerikborge]

Quick Warning! Make sure your custom panel is not longer than the maximum panel length the dishwasher supports, otherwise you will not be able to open the door all the way. The max panel length is written on the bottom corner of the template. If it is too long you will have to lower your dishwasher. Learned the hard way.

[garykeirke]

Brilliant straight forward instructions velcro has a lot to answer for!!🥵

[martinjohansen]

If I don't got the template, what are the measurements for the holes? I also got a double panel, not a single one. What do i do?

[jalavena]

In the video you show four screws, can you show where they go?

[aprophet]

Hi great video. Could you please tell me where I could buy a stainless panel like that for my Bosch panel ready dw? Thanks!

[jesuspanos]

Good morning from Spain.
I´d thank your help with my door dishwasher issue. It´s FSB52600Z model, completely integrated. My problem consists in removing completely the metal door behind the wood panel at the front. I need to replace the rinse deposit and, once I´ve removed all the door screws, there are still two clinches (or similar) at the bottom which I can´t remove, and the metal door keeps hanging from them. Any help? Thanks

[lindahaley]

I used the same custom panel with my past 2 Bosch diswashers. This time, the panel needs to be adjusted by shortening, I think, because the door won't open all the way down. So, after we trim it down, what am I supposed to use to cover the 10 inches below the pivot point? And, as an earlier person commented, "What template"? Not in my packet.

[michaelthomas]

How big is the panel? Not sure why anyone thinks this is a great video

[AshWP]

Can someone please advice where to get the custom panel from? We ordered a custom panel ready dishwasher but it came with an unfinished front and no separate panel. Any suggestions on where to get the panel shown in video would be fantastic!

[edsonsessions]

Very unclear what two “middle” screws are to be removed/ replaced

[aktuelni]

Hello, I lose that 2 clips and I door fix only with 2 screw. Where I bay that, on ebay I dont' find them

[isabelsfoodandtravel]

Do you have link to buy hardware to attach the panel?

[dannijames]

Do you call this door kit a fixed door kit or a sliding door kit?

[ohaya]

Hi - We bought an older home with a Bosch dishwasher with a custom wood panel already installed, but the small front handle is loose/jiggling. From your video it sounds like I need to remove 4 screws, but in your video you only show one screw on the inside. I assume that one other screw is at the opposite corner, but can you tell me where the other 2 screws that I would to remove would be? Are they at the inside of the door at the bottom 2 corners? Thanks!

[marilynday]

Can you tell me where the vents are on this dishwasher?

[leifsorenson]

I have a KitchenAid panel fit on a Bosch dishwasher?