GETRAG 360 Shift Top Disassembly and Reassembly

GETRAG 360 Shift Top Disassembly and Reassembly

[MOTOPNW]

Much better video than most Getrag top end rebuilds. I just did mine thanks to your video.

My issue was I couldn't shift into 5th and reverse. Found the roll pin for that shift fork gate came out. When I disassembled the skinny cross pin from 3/4 was broken.

Can't wait to get the first gen back on the road!

[siddiqueshameer]

Thanks, I have searched lot to find shift fork repairing video like this. Very helpful

[nickkumro]

This video is great would have been nice a couple months ago had the same broken spring. Need more videos like this

[La_GMC_Reaper]

Is all that required if I just need to change out the spring?

[ajkemer]

My getrag has problems shifting into other gears once shifting from out of fifth any other time shifts fine just ordered top plate rebuild kit as trans gears and synchronizers are fresh hoping this helps

[milesgerschefske]

solid vid, makes me a lot more confident in rebuilding mine. hoping with the body lift, the stub pulled, and the cross member dropped I'll be able to pull the top cover without removing the transmission from the truck.

[adrianbanks]

Should use a magnet to put in those chubby guys for the detent

[raygarciaelcubanootr]

I have a question on my shifter its really stuck and there is no broken spring I ordered the rebuilt kit to do the rebuild like you did is there anything thing else i need to look for so those three shaft would move smoothly ?

[zackalexander]

great video! where did you get the rebuild kit?

[andreweverett]

Would I be able to replace just my 3-4 fork?

[vex]

Do you know where I might be able to purchase this top cover assembly? I want to use this for building a sim racing rig

[patbrennan]

I have a 89 and it won’t go into 1-3-5. Would that be a role pin trying to come out or do I need to get the rebuild kit with new springs and dent balls ?

[earlgenus]

Just watched your video and I have a problem with it 5th and Rev. The shifter keeps jumping out of Rev. Shift gate hanging up what is the problem. Help!!!!

[andreweverett]

What size punch did you use to take remove the roll pins?

[gagedavis]

My get rag 360 will get stuck in any gear I can get it back in neutral fine with a screwdriver and it goes in every gear fine but the shifter has ton of slop would that be my problem. When I say a lot the shift lever will hit the dash before going into third gear