Interface MCP23017 (Port Expander) With Arduino Uno

preview_player
Показать описание
This video shows how to interface MCP23017 with Arduino Uno.

Download the Circuit Diagram from the following link

Download the Code from the following link

Thanks for checking this description.

Follow us on:

Рекомендации по теме
Комментарии
Автор

how i can used it with common cathode led >> i mean connecting all the Led to one ground and the anode from the IC ?

erbilshops
Автор

So it's a low level (short to ground) triggering signal?

TheDarmach
Автор

you can control one mcp23017 with another yes? so I could put them in row?

ianthehunter
Автор

I would like to use Buttons Connected to the mcp23017, so I would be happy about an example to Set each Port as Input and forward them to an esp8266

bluenazgul
Автор

Hello, great video 😄.

I'm a beginner and I have a question :
Can you use the MCP23017 with the TCA9548A multiplexer?

Thank you in advance for your precious support 😁.
Cordially.

kevinhoublon
Автор

I think connecting A2 A1 A0 and reset to GND and does not make sense - the seem to be pulled down (or up in case od reset) by 103 8 pole 10k resistor on the fron of the board.

TheDarmach
Автор

can your mcp23017 have a random address or where do i find it ? and how can you daisy chain this extender?

reaporofdragon
Автор

sir how can I reset my interfaces to default again?

ianthehunter
Автор

This is simply port expander ic. you can only control GPIO tasks. you can not take input from POT.

EmbeddedGate
Автор

Hallooo...
Sorry for my stupid question:
Can I use MCP23017 for Servo too?
And...
Can I use MCP23017 for input data?
Thanks for your lessons!

Abbici