Cracked my engine block 🥺

preview_player
Показать описание

Рекомендации по теме
Комментарии
Автор

And this is why I get a professional to do this shit, because I’m a complete idiot and don’t trust myself.

Yousifzzz
Автор

bro it's one thing after another 💀

matthewgerman
Автор

It's one thing after another. But look on the bright side, these videos are really entertaining.

snorlax
Автор

I've seen JB weld fix WAY WORSE
Use regular, not the kwick

tayloralvidrez
Автор

It’s the oil pressure sensor on the block seen it happen on a lot of Hondas

mercedesc
Автор

I solout your strenghth and positivity. Hope soon we will see you with a good job.

awadhalial-kalbani
Автор

Pro tip: don't buy a garbage car, could've bought something decent with 2500 instead

luckeypowa
Автор

You have an interested and upbeat voice for YouTube bro. You should do narration

Rap__GPT
Автор

Here's a thought... TAKE IT TO A MECHANIC!

grimace
Автор

Wonder if this is where your current issue started?

gaap-mojx
Автор

Squirt bottle with acetone to steam spray the. Crack completely clean, power wash the crack first with soap, then use only the marine higher strength and temp JB Weld and make sure to use plenty of it spackle into it .That's bad but you might be able to limp short distances till you can get an engine swap .not a cheap fix .

charliegreenler
Автор

I'm guessing the jb weld didn't work?

Ancientcaptain
Автор

I’d try some teflon tape or putty should give u a well enough seal

landonvidaure
Автор

Hello. I'm from the future. A few videos from now. You'll need a new engine. JB weld isn't gonna fix that.

shannonmorrow
Автор

Jb weld aint gonna fix it. Speakin from experience

OG_GeneralPerchie
Автор

Check what pressure that part holds n i bet jbweld might not work most likely new bottom at minimum

chris-dhwy
Автор

over tightening the drain plug will not crack the engine block it was already cracked

tonysigsby
Автор

If you can take it off the engine, take it to a welder. If you can’t, go talk to a welder and check your options

willroski
Автор

I like the comment just weld it up and use the dipstick to drain the oil

tonysigsby
Автор

Depends on what part you Cracow she cause you may be able to weld it but eventually you’d have to replace it

laststar_