BTT SKR2 - A4988Stepper and CR10 (Creality) display setup

This is a simple tutorial on how to setup Creality Ender3 display CR10 on SKR 2 and also setup A4988 Stepper driver in Marlin firmware.

Playlist for SKR 2:

****
WARNING BTT and TMC steppers on SKR 2 revision A
****

One Time Tips, You Can PayPal Me:
Discord:
Patreon:
buymeacoffee:

Hardware:
1 - BigTreeTech SKR v2 rev B
1 - USB Serial cable
1 - SD/TF drive with adapter
1 - A4988 stepper
1 - NEMA17
1 - CR10 (Creality display)

Software:

Documentation:

Pronterface:
RepRap calculator:

[scottsparks]

Ed, as an engineer, I really appreciate how you do your videos. You do the best explanation of anyone I have seen and are very clear about what you are doing. You even take the time to explain things in each video that you have already explained in other videos, just to make sure everyone understands completely what you mean. I also appreciate you mentioning ferrules, as to me that is the only way to work with multistranded wire. I will go through and follow your instructions and double check my configuration. I really appreciate your work and I have been a subscriber every since I saw your first video on you tube. I will let you know how this test works out.

[JoshKindhart]

Thank you so much for making this video! This helped me solve my problem with my SKR-3 EZ on my CR-10 V2

[michaelreichelt]

Hi, what is about BTT Note at3:42 ...you must short-circuit RST and SLP.... where are the mentioned jumper?

[fbaez]

Do you have any videos on setting up the big tree tech ESP07S or ESP12S on the SKR 2?

[DeadWinter]

Could you by any chance make a video covering how to install a creality ender 3 v2 DWIN display on the SKR 2 motherboard?😬

[XynGG]

My screen just stays blank. I'm using a Cr10S. Any suggestions?