How to adjust air regulator truck

How to adjust the air pressure in your truck. 1/2 turn does 5psi increments.
Lower pressure screw in, increase screw out.

[afmc]

Changed my air dryer and my pressure went up to 145psi. I knew it was easy to adjust but needed your quick video to refresh my memory. Thanks!

[derrickzenner]

Worked for me. However because of the close proximity of the intake manifold on the 12.7 detroit it was facing the engine block, basically the regulator was upside down compared to yours, with very little room to work with so I had to remove it from the compressor and adjust it. only two bolts hold it on. Not hard. Thanks for the info about which way to turn it. It saved some trial and error.

[jamisonmiller]

Thank you because I didn’t know how to adjust it

[jaimeramos]

Thank you sir i subscribe to you channel very helpful god bless I was able to get home😂

[TractorsNStuff]

Mine is dumping the air dryer at 100psi. I'm going to try to this adjustment. Thank you!

[sheldonbaccus]

Thank you sir i sure needed this info thanks for knoledge👍

[Elvinrosario]

Thank you for your help God bless you all

[petergruben]

135 psi is for b-trains and belly dumps and 120 for normal use

[josecastillo]

Fucking great video man! Thanks for taking the time to share the knowledge 🙏 straight and to the point.

[gracealvarado]

Thank-you very much... I appreciate it..

[vladizlatko]

Thanks bud for the info, greatly appreciated!

[d.j.robinson]

Great video, so just to be clear, you turn the screw clockwise to lower the pressure..?👍🧡

[eugeniujosanu]

That's what I was looking for, mine started to act stupid and opens the release valve at 105- 110 psi.

[destinysimmons]

Is this only for the Tractor. I a not getting air to the trailer and all the valves are fine. At least to what I can see

[bernardsjr]

My secondary, which is the front needle (green) doesnt go over 100psi just the orange one my primary goes up to 120psi, any idea what my problem might be

[secomeco]

What do you mean you screw in you mean right or left?

[joejohanning]

Thx. Mine 150. Better go down. Blow the truck up

[Cubanguy]

Does anyone know the name of this part?

[waynenunes]

can a bad air governor cause the compressor to not build any air at all ?

[jamisonmiller]

Because my pressure is at 140 and it stays that way it won’t go below 140