K2 Plus First Layer Issues

Creality K2 Plus 3d Printer printing a First Layer. Some Parts are Good Some are Bad. I've done the standard calibrations, such as bed levelling, flow and pressure advance. I cannot seem to get a consistent first layer with this new filament i got. The filament is ESun ABS+. After a few layers, it's prints very well. Any suggestions on how to resolve this bad first layer? Comment below!

[nickcsuki]

Had this issue too. Pre heating the bed for a while before starting, a slow first layer and a higher lauer (0.28) fixed this for me.

[rDinaryRob]

I usually use a slightly higher temp for the first layer..

[zombai]

Slowing down on first layer drastically, like 30-40mm/s helps a lot on standard PLA. If it's not high flow it's not high flow.

[joelrowe]

Nozzle is too close, at least that was my issue. Why I have to manually adjust the nozzle mid-print after it calibrates the whole bed is far beyond my comprehension

[JustSomeHuman-jo]

My K2 prints an incredibly good first layer, right out of the box. 😃

[ahmetsehovic]

Why when i put a gcode in my usb and start printing it it does not print

[slottygwwvw]

Creality 101 always good on paper and extra bad terrible in practice

[ananasv]

please check your gantry if is not loose like mine. bought 2 k2s both same .whole gantry loose impossible for me to do first layer same like you

[Akki_Ke]

Adjust/trim your bed manually. Calibrate the printer, if it has that function. Clean the plate with warm water and soap. Maybe clean with IPA if necessary. Don’t print PLA after you printed PETG and vice versa. Have fun.

[gionatananimobono]

The First layer Is too fast. Don't use the standard setting

[javils]

Menuda porquería de impresora un infierno desde que la compre