Configuring Inter-VLAN Routing on SG350 and SG550 Switches

Learn how to configure Inter-VLAN Routing on SG350 and SG550 Switches

[greghaa]

For SG350 under VLAN Management -> Interface Settings, you must set the ports to Layer 3. Layer 2 will not route between VLAN's. The video did not cover this.

[mrcgeraldes]

This has to be This just shows hot to create 2 vlans. Not hhow to forward traffic between the 2

[obadvw]

this doesn't work, devices can't reach each other on different Vlan

[seconds]

I don t know about the specific settings in a SG350 switch, but in my SG250 i first needed to activate the "IPv4-Routing" checkbox under IP-Configuration > IPv4 Interface...

[christophersaunders]

Hi and thank you for this video.

Following the steps detailed here on my SG350-10P switch, I'm not able to ping the other vlan when connected to a configured port.

[igorsimonovic]

I bought cisco sg350X-48 because of inter vlan routing. When i do the same setup as in video in cisco packet tracer it works. But when i repeat in real device it simply doesn't work. It should be easy but it doesn't. I do not know if I am missing something.

[akhmedsaymaev]

I have some ports disabled after power off on the cisco switch how to enable them through the web interface

[haybolrambol]

how can I configure VTP domain name in this kind of cisco switch? thanks

[-io]

It doesn't work at all. I don't understand, why CISCO is publishing a video with the incorrect instructions. Or this is the advertisement for a spokeswoman from CISCO?

[akhmedsaymaev]

Configured only through the terminal CLI

[IvanRosaT]

This is great ! I can ping from each subnet their default gateway, although I dont have internet access among them, how to fix that?

[andresavoie]

This definitely does not work on a SG350-10MP I have one and I set it up exactly the same, well I sent another route to 0.0.0.0 0.0.0.0 also via default gateway 192.168.0.1

[jh]

I connected the SG350 to a TP-Link TL-ER7206 router and an ASUS RT-AC3200 router. I followed the Inter VLAN instructions in this Cisco video and it would not work. I created VLANs 2 and 3 and enabled IPv4 routing in the SG350. I left DHCP enabled in the routers and they gave the SG350 VLAN IP addresses. After experimentation and further reading, I used static routes in the routers to direct traffic to the VLAN(s) and everything works. I do not know if Layer 3 should be used, but I left the interfaces at Layer 2. The Cisco videos are uninformative and make if difficult for anyone new to networking. Why not include some useful basic information in the video?

[nooraalam]

Kindly, Make A Video On Trunking Between 2 Cisco SG350 Series Switch

[lokeshsingh]

Bought sg350..I have 2 vlans and 1 vlan default have internet ..but the other vlan is not able to reach to the internet..what should I do now?

[rosssnow]

This absolutely does not work on my SG350-G. Started with brand new switch and factory default settings. I can ping across VLANs to each VLAN interface IP, but not across hosts on each VLAN.

[petsworld]

How to find each device of ip address in sg350 switch and how to know ip address of each switch

[Avael]

Am I the onlyone noticing that she is using Windows on a MAC?....

[itbaljit]

not working in sg350 switch i have 5 switch. don't waste your time i do same setting but pc not ping other vlan