DETAILED INSTRUCTIONS: Fix LIMP Mode Once and For All

preview_player
Показать описание

LOVE building things at home? ▶️ SUBSCRIBE ▶️ and reach out anytime in the 💬 comments 💬.

0:00 BMW E46 Troubleshooting limp mode
1:17 Testing the BMW e46 ICV (idle control valve)
2:25 Test the BMW e46 accelerator pedal and DISA Valve
3:06 Testing BMW e46 throttle body
5:20 Replacing fuel pressure regulator vacuum hose
6:22 Test driving BMW e46 for limp mode

We participate in the Amazon Services LLC Associates Program and are an Eastwood Ambassador. When using our affiliate links, you are helping support our site and us as creators. Thanks!!!🙏🙏🙏

We assume no liability for anything you choose to do to your automobile/home before, or after reading or watching one of our videos. Working on your automotive/home should be done at your own risk.
Рекомендации по теме
Комментарии
Автор

Thanks mate! Awesome tutorial, much appreciated! 🙏

SirFrancoQ
Автор

2011- 323i. The automatic transmission stopped working last night. I pulled up at a traffic light and when the light changed I tried to accelerate and the car would not move. Just before this happened I heard a pop and thought a tire had burst. The car will not go forward or reverse. Had to get the car towed. No warning lights or engine codes and the car was running fine up to the stop light. Any ideas of what the problem could be ?

jamesweber
Автор

I replaced my throttle body icv and disa and still have the code 1580…. I’m irritated now any help would be appreciated. Although I don’t expect anyone to reply.

jin
Автор

So I'm now subscribed. Thank you so so so so(and many more) much.

marcjohnson
Автор

I need one the reference books. For 03 z4 3.0.. where could I get that plz?

lucindajohnson
Автор

Can you tell me where the sensor is located? I've been looking for two days and I haven't found it :(

Triplaajat
Автор

I floored my 98 E36 328i going 0-60 and around 10-15 minutes later my transmission light turns on and the car entered limp mode (I think) and plus whenever I put the car into or out of park, it jerks very hard and the rpms raise and then go back down pretty low (it’s an auto transmission)

anthonykartavenko
Автор

E46 N46B18 engine error "vvt self learning function lower learning range" 2A61,
relearning via INPA helps drive another 200-300 km, sometimes after oil changed till 1000km, but then error appear again, relearning was done more than 100 times. Has anyone encountered something similar?

rommevras
Автор

My BMW 2005 325xi has code P1635 and code p0341 and it’s been put into limp mode with the fault codes and I’m not sure on how to fix the p1635 code

ImSlySnipes
Автор

Hi i have a 2011 bmw 328i and I am currently experiencing limp mode after accidentally touching the live nut/ bolt located in the front of the car and under the hood which is associated to the positive wire causing a spark. Please help. Thank u.

MariPinoyHill
Автор

Nice and thorough vid! Just had my 328 go into limp mode and came across your video. My throttle body was sticking shut a bit ( the car doesn't get used much) so I think some cleaner and start there. I had both rubber boots between the mass airflow sensor and the body split too which won't have been helping!

YootubeUK
Автор

Just curious, shouldn't the throttle body valve open a bit more than that when accelerating?

dhalsim-
Автор

6 pm just tried clicking my fuel cap filler 6 times on my jag xf cured problem brilliant

paultaylor
Автор

I haven’t checked but would it still be the pressure, if it acts like it’s pouring gas out faster than I put it in, won’t shift 5–1 won’t drive unless I gas it and aid i floor it the don’t even act like I’m flooring it

gamestompper
Автор

Does it matter which pin u connect the alligator clamps? Is there specific side for negative or positive?

bbblahoo
Автор

Hello i have bmw e46 with eml light problem but the eml and check engine light pops up when engine get working temperature cold engine runs fine without any lights. If you turn off car and turn it again rev it it just go to the limp mode again imediatly.

gtagamer
Автор

Im experiencing limp mode as well, but the codes im getting are P0171, P0174, and P0305… lean codes and misfire on cyl 5… wondering if new pre-cat O2 sensor and new MAF will fix it.. any input??

-zargati-
Автор

does anyone have idea what could it be with my car it its in limp mode for months, pre supply fuel pressure low (changed pumps) and last week well it cracks but wont start only with starter spray then drives (in limp mode) BMW E39 525d M57 engine

Somebody-lnni
Автор

I have a 99 328i and it only goes into limp mode when I put the pedal all the down but once it's into limp mode I have to constantly turn it on and off until it goes away and my check engine light will go completely off and it drives fine certain times. The only thing I could think it could be is battery is done and it can't pull enough power for car to maintain as I've recently got oil change and oil service reset as I thought it was that but nope. Any help is really appreciated 🙏

ZIEVAX
Автор

I just got a 05’ 325i and the trans and engine are brand new, it’s in limp mode as well and only gets up to 3rd gear, any thoughts on that? I’ll be working on it tomorrow

iniixi-