Assembling a 7mm, 10mm, 20mm or 30mm PRO Quick Connect Generator Probe

Assembling 7mm, 10mm, 20mm and 30mm generators
The following instructions are for the assembly of all other generators except 5mm.
Slide the lower bearing onto the rotor shaft.
Attach the rotor knife to the rotor shaft by screwing it together until tight (hand tighten).
Insert the Rotor Shaft into the end of the tube and collar assembly. Then push the rotor knife up into the end of the tube and collar assembly until it cannot go any further. This will put the lower bearing into its proper place. The rotor shaft should stick out through the upper bearing located in the top of the tube and collar assembly.
While pushing against the rotor knife, place the PTFE washer over the end of the rotor shaft and put the rotor collar assembly onto the rotor shaft.
While holding the rotor knife, align the setscrew on the side of the rotor shaft collar and the flat end on the rotor shaft so they are facing each other. Once lined up with one another, tighten the setscrew against the flat end of the rotor shaft using the hex wrench end of the screwdriver tool (supplied in the tool kit).
Insert the ¼” hex key (supplied in the tool kit) into the end of the rotor shaft collar and insert the screwdriver end into the rotor knife and turn the hex wrench clockwise to confirm its tight (Over tightening of the rotor knife onto the rotor shaft can result in breaking of the rotor shaft and/or distorting of the rotor knife).