Soldering SMD's with a DIY hot plate

preview_player
Показать описание
As you might have noticed, there was a bit too much paste applied, which resulted in a lot of solder balls (which I cleaned up off camera).

Normally you should use a stencil or apply the paste a bit more carefully. But since this was a board I didn't really care about, I didn't bother with it :)
-------------------------------------------------------------------------------------------------------------------------
Affiliate links to tools used:
Рекомендации по теме
Комментарии
Автор

What's the melting temperature of the paste? Don't the components get damaged when everything's heated up so slowly?

saiiiiiii
Автор

Ain’t no way it cleaned up that nice, it was so sloppy at the beginning. Are you sure you didn’t pass it off to someone to clean up? 😂

ZeFoxii
Автор

What’s happening here? I’m gonna have to research a little more.

SoulSingerJTait