KOSO APOLLO HEATED GRIPS INSTALLED ON YAMAHA XSR900 MT09

“STVRBOY”

2 pin MT .090 - 2.3mm Male locking connector

0:00 Intro
0:54 Seat and Tank Panel Removal
1:43 Fuse Box Disassembly
2:20 Handlebar Bar End Removal
3:01 Stock Grip Removal
4:45 Heated Grip Wiring Setup
8:26 Heated Grip Install
11:33 Tank Removal
12:33 Heated Grip Wiring Harness Install
15:45 Tank Install
17:09 Test Grips
17:37 Adjust Grip Wiring Slack
18:10 Install Fuse Box Cover
18:26 Install Tank Panels
19:16 Zip Tire Grip Wiring
20:18 Bar End Installs
21:20 Mirror Install
21:26 Outro

[mikakey]

How did lining up the buttons on the grip with the blinker switch go? No accidental bumping the grip switch often? I'm doing mine tonight and wasn't sure if I should offset them a little

[jonathanfrancisco]

Nice! Makes the decision to ride on a chilly day that much easier

[daveb]

Hello from the UK..have these on my 2018 Suzuki GSXS1000…wired them into the switched live connector already in place if you wanted the Suzuki grips. Work really well & look good to. Don’t get as hot as Oxford grips but still warm your hands great 👍 nice job

[roblepack]

Thanks for the video. Very useful! I’ll be installing a set in weeks ahead. I plan on using a relatively generous amount of glue so it doesn’t dry too quickly. As a side note, I doubt that heating the grips with hair dryer/heat gun would much to get them off. If so, they would get loose on their own when they are on.

[Porrkyy]

Awesome Vid, Looking to get some for my XSR very soon as I want to ride in the winter. One question which unrelated to the grips, which bar ends do you have? trying to find one similar that can screw on and have a pair bar end mirror but cant find a pair. Thanks in advance

[Boadhionwheels]

I haven’t removed the grips on my 2019 Tracer but almost every other bike I’ve had, I have been able to remove the grips with my air compressor. Have the trigger tip in one hand and pliers in the other. The compressor will expand the grips and use the pliers to pull on the grip.

[thaspaniard]

Thx for the video! I've got a set ready to put on my FZ09. I was concerned about simply putting a larger 5amp fuse to feed the accessory plug (electrical engineer I'm not). Have you had any issues on that circuit with the larger fuse?

[filabila]

Great video, how do you like them 5 months later? Thinking about putting these on my FZ09. Could you have put a spacer washer in the throttle side bar end to extend it out while still being able to tighten it down? Just an idea. Cheers awesome video

[seaninness]

If you would, please let us know, how they work out. The comfort level, how much further into cold weather they get you and any expectations they exceed or don't meet. Did you consider heated gloves at any point?

[adiohead]

How do they perform?

I have the Yamaha grips on my XSR900, but they are rubbish. Not hot at all (and they are set correctly for the right CC).

[gomes]

Hi
Can you tell me what the outside diameter of the grips is?
Thanks

[unaetnumitsirc]

Do they fill thicker than the stock ones ?

[captonlocation]

Omg...Is more easy to put off your grips if you use a wrench ( at the beginning of the handle) and you hit with an hammer the wrench you will see that it will come out without problems. Try