M1 CALIBER Demonstration - REEKON Tools

Показать описание

The M1 Caliber is a fully integrated, patent pending, measuring tool that clamps to almost any kind of saw fence and outputs measurements of materials slid underneath its wheel on a large, backlit, LCD screen. This Augmented Tool is more accurate, faster to use, and safer than traditional methods.

Please ensure all proper techniques are used for cutting and material handling when operating a saw of any kind. Manufacturer's directions and safety recommendations should be followed at all times while operating.

Рекомендации по теме

Комментарии

Can’t wait for it saw it tool review zone this is just what I needed cause my tape measure gets taken, falls out of windows or my tool bag/belt and I forget to go grab it or just completely forget it fell out then I’m at saw looking all around

droNGM

Great stuff. I look forward to being about to purchase it direct from your website rather than kickstarter. After a few terrible crowd funding experiences where no product was received and no help from kickstarter i'm happy to wait until you successfully launch and offer the unit as a retail sale. I'll accept the price rise.

hurcorh

What if you want the measurements to be to the left of the blade? My cut table has more room to the left of my saw.

tojo

Is each device calibrated at the factory to accommodate for variance in the rubber wheel diameter? What precision and accuracy does it provide?

ko

@Reekön Tools ... how do you set up the different thickness of the saw blade? Could you explain it or make a YouTube video for this issue?

wolfgangselle

Is it only for straight cuts or can you cut 45 degree cuts for door or window casing? Second you have 10 cuts of the same you have to zero it out after every cut? In the video it shows the measurement increasing everytime you put the wood under the

hazmat

I cant wait for the Kickstart! I am poised and ready!

roy

For precision of 0.02" it is quite off at 1:24. What about precision after some time when the wheel gets worn out or with a dust build up on wheel?

Slemi

The way you've demonstrated that you'll always be the thickness of the saw-blade short of your desired measurement. Butt a piece of stock up to the right side of the blade. Clamp in place, lift blade, slide the stock you want to cut up to the clamped piece and set the M1 to zero. Remove the clamped stock. M1 is now 'zeroed in'.
Excellent idea and I'd look at getting one.

tymbian

I'd have to hook it to the right side of my mitre saw and no more bevel cuts. They'd have to be done on the table saw. I have 73" to the left of my saw and 60" to the right. This tool would take up the 8" I have no tape measure on the fence because of the wings. Made my center table too big.

christopherdekonstrukt

Have another question. Hows does this device handle short cross cuts? Meaning, If I need to cross cut 2 1/2 inches off a piece of 2x6, how would I do that with this device? I see that it sits on the fence. Based on the videos, if I set that device on the fence in the same area, roll that piece of 2x6 past the roller underneath the device and get to 2 1/2 inches, it looks like the wood would not even make it to the fence.

robertknowles