Victron MultiPlus hybrid inverter charger 12/1600/70,

victron mutiplus inverter charger fitted to my Motor Home

[samhartfieldlewis]

Brilliant explanation, thank you for your help

[yilmaz]

Nice video I am thinking of buying one of these. Thank you

[metalsnapper]

Victron measure their 230V output capacity in VA, so unfortunately, you actually only have just about 1300W of available power and this decreases with if the unit gets hot.

[peterpulpitpounder]

I have a technical question I need help with. I am running a pellet stove in my house, which only draws a maximum of 3 to 5 amps, and no more than 400 watts. It's actually less, because I never used the igniter. So it's more like 200 watts and 2 to 3 amps. The fuse I have chosen is 80 amps. My inverter charges my 200ah battery at 40amps and is rated at 1000 watts. Here's my question. If I only use my setup for my pellet stove, and I never draw more than a few amps in use, is my 80amp fuse more than enough? The recommendation is much higher, but I am assuming that is with the idea of drawing much more of the 1000 watt capacity the inverter offers. I'm using 6 gauge cables, and they are only a few feet long.

[richardweerasinghe]

Nice video. I’m looking at installing one in my overlanding vehicle. Don’t you need another AC breaker on the output side? Not quite sure if it’s needed.

[GaryATC]

Nice helpful video, may I ask the size of your battery and type.

[Elites-asthetic]

A question buddy from what you said . you say the Victron ac out goes to all van 240v sockets
but have you got it running to another rcd or rccb or mcb breakers
Otherwise it will be used for microwave if have one . Water heater or space heater . then anything you plug in to other sockets
I believe you get a total of 5 sockets

[sonnyvallgren]

I don't see any fuses on the red wires close to the battery?
Be careful when you make installations, all red wires must be fuse protected as close to the battery as possible.
Otherwise if you get a short circuit somewhere in the 12v system the wires will take fire.

From the manual.
The product must be installed in a dry and well-ventilated area, as close as possible to the
batteries. There should be a clear space of at least 10 cm around the appliance for cooling.

[barrieathey]

Hi Sam, Does the 200 gx switch have to be switched on, to trickle charge the starter battery? and also do I have to be connected to EHU for it to work? Motorhome is in storage and no ehu available.Many thanks

[alexanderbailhache]

Did the unit come with the AC in/out plugs?

[Diarmaid]

Hi What size of fuse is on the positive cable from the multiplus to the house battery?