Homemade Hot Wire Foam and Styrofoam Cutter (Complete Easy Tutorial)

You can incorporate the temperature controller into the wire for better performance.

Material
• Wood for the frame (you can use your own material)
• Screws
• Switch
• DC Power Supply Socket Jack Female and Male
• DC power supply adaptor Output: 6V DC/ 1A (Good voltage and current will have a better
compatible with your wire)
• Heat resistant wire (Nichrome Wire)
• Adhesives
• Electrical wires
• You can add or modify any materials and specification

Cautions Cautions

• Do not use AC direct power source 220/110
• Use a small amount of DC volt around 3-6 volt. It is enough to test your prototype
• Make sure safe with hotwire!!!! it may cause some damage to your skin !!!!
please consult people around you if you not are well familiar with it.

Don’t forget to subscribe
for any tutorial see
enjoy!

[johnphilipbagatnan]

can you write down the materials used please? and how did you connect the wires in that female jack something... Thank you

[vinopit]

So we basicaly dont need a voltage power controler?

[wesutd]

Please Subscribe for support it is a LOT for me. Thanks

[gilbertreyes]

What kind of screw did you use to adjust the wire ?

[useitwice]

Built to last I see ^^
What kind of glue is that?

[DishopJaya]

Adaptor berpa volt dan amper bos ? Terus ukiran kawat nikelin berpa mm ?? Mkasih

[iXmerof]

Good idea, but too many begs for subscription. One is enough

[floydstime]

You need to either take this video down or provide the tolerances and specs. Its important to know how many amps are running through that wire!!! Someone could get seriously injured if you dont provide electrical specs!!! Seriously!

[markemery]

Not very informative no measurements or even what materials to use