How to dose with Fernox Express via TF1 Omega Filter

Brief How-to video to show how to dose heating system with Express products via TF1 Omega Filter...

Fernox Protector + Filter Fluid Express

TF1 Omega

To keep up to date with latest news from Fernox, check us out on Social Media:

Facebook:

Twitter:

Instagram:

[frankbadhams]

The adapter that is sold with the can is not the same as on this video and does not fit the drain valve of the filter. I have looked at other sites and all seem to have the same adapter

[jimroberts]

OK so I can open the drain valve of the filter to clean it. I can make fluid come out of the pressurised can. However, when I connect the can to the filter, open the valve and pull the lever on the can, nothing happens. The hose isn't kinked. I can work round the problem by squirting the can contents into the header tank, but there's a cheaper version suitable for doing that. Answers please on the back of a clean £10 note.

[sicereluv]

I have followed these instructions to perfection and have had the nozzle come off the pressurized can and spray all over the place and yes the inlet and drain valve have been open. What do you think is the problem?

[Teribus]

I have the TF1 filter without the inlet and outlet valves in the line. I am about to clean the filter out and will be adding F1 protector and F4 leak sealer (I have a small leak on a radiator and I'm going to see if F4 can seal it before I replace the rad). Can the two products be added one right after the other, or do I need to add one, circulate it then add the other?

[trevorrogers]

By opening the inlet valve before charging, does this not put the inhibitor into the mains? I would have thought it should be the outlet valve open then inject the inhibitor, into the system, close the drain valve, remove canister, replace drain cap, open inlet valve.

[alanproctor]

Are you not better dropping a bit of pressure from the system before adding this then top up the pressure as required? as could it over pressure the system?

[cfgman]

Where can i find the serial no for the 28mm filter the builders have managed to lose the packaging

[victorschepers]

This Fernox F1 is that oke for my Alupex pipes in the floor and als oke for a modern central heating unit???

[markjenkins]

I have no valves leading to my magnetic filter, can I still use this ?

[youknow]

You guy's need to improve instructions on the canister, it's very misleading for a non professional. Created headache without reason.
This video is very clear, and very different from the instructions on the canister, which so simple they lack sufficient information to do the job.